Misco Jobs  |  Go to Job Seeker's Center »»   |  
 
«« previous resume Resume #22786 next resume »»
CONTACT INFORMATION:
View contact information...

OBJECTIVE
* Career position where I can utilize my engineering skills and business experience to develop efficiency in a professional organization.

EDUCATION and PROFESSIONAL QUALIFICATION
* Bachelor of Science in Mining Engineering, December, 1980, University of Pittsburgh, Pittsburgh, Pennsylvania
* Registered as Engineer-In-Training, Commonwealth of Pennsylvania

PROFESSIONAL EXPERIENCE
* September, 2004 to Present: Waste Management, Suburban Landfill, Inc., Glenford, OH. Employed as Landfill Engineer. I am responsible for engineering for three (3) sanitary landfills in the southeast Ohio area. Duties include: Project management, environmental oversight, budget preparation and management. I have overseen two (2) cell construction projects and storm water management. I administer bid documentation and specifications. I assist site personnel in Landfill Gas Systems, Leachate Management Systems, and Water Protection Systems.
* April, 2004 to September, 2004: Self Employed. Assist engineering consulting firms with special projects, mainly in mining, earth moving, and environmental fields. I have a Hobby Business of outdoor woodworking projects. I also assist my wife with her home interior sales business.
* October, 1988 to April, 2004: Murray Energy Corporation. I have held several positions for these companies under the same ownership. During this period, annual production increased from 2.2 Million tons in 1988 to over 23 million tons in 2003. Each position change represents a promotion.
October, 1995 to April, 2004: Maple Creek Mining, Inc., Bentleyville, PA. Employed as Chief Engineer. I was responsible for all engineering to operate two (2) bituminous deep mines, a coal preparation plant, three fine coal slurry ponds, two coarse refuse disposal areas, and several support facilities. This work included; overall mine design; compliance with federal, state and local rules, regulations and policies; environmental oversight; and development of annual operating budgets. During this period, I also served as a member of the board of directors for the Pennsylvania Coal Association.
March, 1994 to October, 1995: The Ohio Valley Coal Company, Alledonia, OH. Employed as Senior Project Engineer: During this period I worked on business development and acquisitions. I performed business evaluations of potential mine acquisitions and conducted Phase I environmental audits of the liabilities associated with the acquisitions.
February, 1992 to March, 1994: Oneida Coal Company, Inc., Sutton, WV. Employed as Chief Engineer for this operations that included eleven (11) small bituminous deep mines, three (3) surface contour strip mines, two (2) coal preparation plants, two (2) rail loadout facilities and three (3) refuse disposal areas.
March, 1990 to February, 1992: The Ohio Valley Coal Company, Alledonia, OH. I was employed as Mining Engineer. Duties included preparation of air pollution and environmental permits for the Ohio Valley Coal Company and its related companies. I assisted in the development of acquisition properties.
October, 1988 to March, 1990: Energy Resources, Inc., Brockway, PA. I was employed as a Mining Engineer for this bituminous surface mine operation that included twenty two (22) active surface mine operations, two (2) coal crushing and screening operations, and two (2) rail loadout facilities. I was responsible for all permit activities and environmental compliance.
* 1988: Power, Inc., Osceola Mills, PA. I was employed as an Operator/Supervisor of a heavy media coal preparation plant that used a unique fine coal recovery system developed in Belgium. During this period, I worked with an international work force to maximize efficiency of this fine coal system.
* 1987: Skelly and Loy, Clearfield, PA. I was employed as a Mining Engineer for this engineering consulting firm. My primary responsibilities included preparation of surface mine permits for various clients.
* 1984-1986: First Century, Corp., Mildred, PA. I was employed as a Mining Engineer for this Semi-Anthracite surface mine operation. This operation included three (3) active surface mines and a heavy media preparation plant.
* 1983: The Oasis Tavern, Inc., Philipsburg, PA. I was a managing partner of this tavern/restaurant operation.
* 1977-1982: Barnes and Tucker Company, Barnesboro, PA. I was employed as a Mining Engineer from 1981 through 1982. My responsibilities included mine design and preparation of ventilation and roof control plans. I was also responsible for environmental and quality control. Prior to graduation from college, I worked as an hourly worker in the underground mines during off semesters.

OTHER SKILLS AND QUALIFICATIONS
* Strong computer skills including proficiency in Microsoft Word, Microsoft Excel, Word Perfect, Lotus 123, AutoCAD, SurvCADD and other programs.
* Strong Organizational Skills
* Supervisory Experience of both Technical and Hourly Employees

View contact information...
«« previous resume next resume »»
Search Results (Resumes 2101 to 2150 of 3130)Go to Search Parameters...
Brief Description
Mechanic/Welder Field, shop, underground
Masters Degree Construction Management / Experience on Multi-Billion Dollar Greenfield Projects / Russia Experience / Civil Field Engineering / Contracts Supervision & Administration / Field Supervision / Construction Management / Scheduling / Estimating / Specification and Procurement of Materials
Rotating & reciprocating equipment technician
design construction, budgeting, drafter, supervisor
I am an engineer holding a university degree (B.Sc) in electrical engineering Aden - Yemen, I have 8 years experience, 5 years in electrical & electronics maintenance and 4 years experience in a Company in Saudi Arabia has Industrial agencies responsible of after sales services
Ihave completed Btech in Mechanical Engineering from Sree Venkateswara University campus with an aggregate of 80% idid the courses of Pipe Designing system,Auto cad2006
• High financial and numeric ability, establishment of policies and guidelines, playing many strategic roles for Multinational Companies’ Branches in Ecuador, South-America (+15 years)
Comptency Training Specialist - Manager
I have 10 years experience in instrumentation and control field. I have designed, installed, tested, calibrated, start up, commissioned, maintained and repaired industrial electrical and instrumentation control systems and skilled in PLC, DCS, Programmable drive based control systems.
Grader Operator at Stillwater Mining Company. Have 2 years experience in underground road construction.
I am a CCO crane operator willing to travel.
Mining engineer with experience in strip mining and underground metals mines. Graduating with Master in 2007. Techinical interests in cut and fill mining.
Expertise in SIEMENS PLC & SCADA, B.E. (Electronics) from University of Pune
Systems Engineer - SW HW Server Client Microsoft Linux Unix - networking WAN LAN VPN WLAN routing switching - Physics degree and scientific work in high voltage and superconductivity - 2 years mechanical engineering - relocate to anywhere - fluent English, German, French, some Portuguese (braz.)
Supervisor Field Geology responsible for the non-geological aspects of diamond deep drilling program and reverse circulation grade control drilling program as well as in sampling.
Underground miner / operator
I am having industrial sales experience of around 8 years in Hydraulics & filtration system & its component sales.
MSc environmental sciences with a strong focus on air pollution and health risk assessment
GSM/CDMA Project Manager
6 years working with different equipment NCCER certified level 3
Dump Truck, Back-Hoe, Cat
Sr. EHS Manager Professional, 20+ years
I would like to thank you for taking the time to look at my resume. I have no underground mining experience but I am confident that I can catch on quick.
Free! Experience in both mining and construction industries throughout Western Australia both remote and metro.
I wish to continue to expand my skills and further myself within the field of diesl fitting
Im msc chemistry qualified chemist worked in iron ore mine in diff field as sampling,chemical and physical analysis, administration
12 years experience in the supply of drilling consumables with 2 years experience in logistics of same. Have done field work and managerial work.
Senior Contract Engineer Trilingual English/French/Spanish Oil and Gas industry, experience in Africa, South America, Europe. Working for a major international engineering company. Mainly contract formulation and admin. but also project and construction management, cost control and planning.
Experienced Engineer, Diverse Background, Mining, Environmental
● Mechanical Fitting Certificate,Rigging certificate,Safety and Health Stewards certificate,First-Aid in mining certificate,Certificate in computer application software packages and in possession of a clean drivers licence
Emergency Response instructor/ Safety Instructor/ Security consultant
Project maintenance manager/planner/trainer
Graduate in mining engineering,MBA in Operations Management,5 years experience in opencast mining
I am interested in pursuing a geological career and will be graduating with a Bachelor’s degree in geological sciences from Arizona State University in May 2008. I will be a great asset to your company because I am a fast learner with strong work ethics.
Registered Electrical Engineer and trained Quantity Surveyor, able to combine technical knowhow with commercial understanding into Quantity Surveying, Estimating and Sub-contract Administration
IT professional with 7 years of professional experience in diverse roles; varying from software architect, process engineer, project leader and software developer.
Complete Facility Maintenance
Country Manager, Nigeria, The Olive Group. Formerly Chief of Security, River Ranch diamond mine Zimbabwe, corporate security manager, Riyadh, security manager KPC Indonesia, Graphtan Tanzania, 23 years in British Army Int Corps, Worldwide experience in military security operations.
Maintnenace Foremen looking for longterm employment
Metallurgical Engineer
I am a highly qualified, experienced and creative professional seeking a Design/ Drafting Engineer position in your Organization to utilize my excellent skills and passion for challenging work.
Civil/Structural Field Engineer. Construction Management with large EPCM projects
Extensive Experience in the industry!!
To handle financial and management accounting position, and be directly involved in accounting, financial analysis, budgeting and other areas of finance, accounting.
B.Sc Engineer in Metallurgy & Materials Science with 10+ years experience in Quality and HR department
Surface Mining
Instrumentation, Automation, control & electrical engineer with 3 years experience
My skills and qualification are exemplary
HSE - Occupational Health Doctor / HSE management / First Aid Instructor / clinical doctor with interest in environmental health , public health and tropical medicine
Catering Specialist
First   1   2   3   4   5   6   7   8   9   10   11   12   13   14   15   16   17   18   19   20   21   22   23   24   25   26   27   28   29   30   31   32   33   34   35   36   37   38   39   40   41   42   [ 43 ]   44   45   46   47   48   49   50   Next   Last
Seach Parameters

Change search parameters...
INDUSTRIES: Mining;
Change search parameters...
Keywords: (e.g. mining engineer)Find results with:
Save this search parameters...
Post job with this search parameters...
Frequently Asked Questions
What's the most effective way to perform a search?
Go to Advanced Search
1. Select 'Industries', 'Categories', 'Education', and 'Experience' fields. Click 'Search' and look through results.
2. Enter one or two of the most important keywords. Click 'Search' and look through results.
3. To search within results add more keywords.

How can I find resumes that contain specific exact phrase?
To search for an exact phrase, just put quotation marks around two or more words, for example "mining engineer". Use this feature to narrow your results or to find words that can be typed differently, for example AutoCAD "Auto CAD".

More Frequenly Asked Questions...
Employer's Center


» Employers Home
» Feedback
» Help

» Post Jobs
» Edit/Delete Jobs
» Search Resumes
» Resumes By Email

» My Account
» Log In

» Log Out
 
©1999-2008 Misco Jobs. All rights reserved.  Contact: support@miscojobs.com