Misco Jobs  |  Go to Job Seeker's Center »»   |  
 
«« previous resume Resume #40445 next resume »»
CONTACT INFORMATION:
View contact information...

OBJECTIVE
To obtain a position as a geologist in a geology related company

EDUCATION

CORNELL UNIVERSITY, Geological Sciences Department, Ithaca, New York£¬ USA
Visiting Student, temporary research assistant: September, 2005 - Present

UNIVERSITY OF TEXAS AT EL PASO, Texas
PhD candidate: May 2005 GPA 3.60
Major: Geological Science
Dissertation: Quartzite Crystallographic Preferred Orientation analysis applied to the Mazatzal-Yavapai crustal boundary, Needle Mountains, Colorado

Master of /Science Degree: May 2002
Major: Geological Science
Thesis: The structural geology and tectonics of the Southern Franklin Mountains, El Paso County, Texas

CHINA UNIVERSITY OF GEOSCIENCES., Wuhan, China
Master of Science Degree (uncompleted): May 2000 GPA: 3.5
Thesis: The laboratory study of Quart rheology.

HEBEI COLLEGE OF GEOLOGY, Hebei, China
Bachelor of Science Degree: May 1993 GPA: 3.70
Thesis: The study of shear zone of Cha Er Tai Group in Baotou, Inner Mongolia.

RESEARCH EXPERIENCE
Rio Grande Rift. Using mapping and field data to decipher the overlap relationship of Laramide orogeny and Rio Grande Rift in southwest Texas.
Precambrian Geology. I am interested in the continent evolution of Precambrian. Currently I am working on the influence of 1.4Ga pluton intrusion on continental accretion of North America which is rooted by determining the P-T history and the complicated structural revolution in the country rock around pluton. Fabric data and samples from Needle Mountains, Colorado were collected during last three years. Making thin section by myself; observing microstructure under microscope; collecting crystal preferred orientation data by using universal stage; compositional analysis for P-T calculation and monazite dating by using microprobe occupied most of my time.

TEACHING EXPERIENCE

UNIVERSITY OF TEXAS AT EL PASO, Texas
Teaching Assistant August-December, 2004
Prepared lessons and equipment; instructed graduate and undergraduate students in lab section of structural geology course
Lecturer January -May, 2004
Prepared lessons, instructed students, and graded assignments/exams for introductory course in Physical Geology.
Teaching Assistant August, 2000-December, 2003
Instructed students and graded assignments/exams for lab section of two introductory courses in Physical Geology and Earth Sciences.

HEBEI COLLEGE OF GEOLOGY, Hebei, China
Mathematical Lecturer January-December, 1992
Taught Calculus I and II at night in a military college.

WORK EXPERIENCE

CHINESE CHANGJIANG NAVIGATIONAL ENGINEERING BUREAU, Wuhan, China
Geological Engineer January, 1996-July, 1998
Geological evaluation of Chemical Jetty, Daka, Mongaladish.
Performed geological assessment in order to formulate a competitive bid for the construction of a chemical jetty facility.

Chemical jetty Karachi, Pakistan.
Prepared monthly reports and coordinated communication with supervisors from six countries. Designed floating drilling platform; supervised drilling and concreting of 1200mm diameter holes for access bridge columns

Qiao Bridge Zhuhai city Guang Dong Province, China.
Designed and constructed 20m*30m drilling platform in the open sea£» Supervised 2400mm diameter holes drilling and underwater concreting them. Conducted testing of concrete hardness

SHANDONG GEOLOGY INVESTIGATION BUREAU, Shandong, China
Geologist July, 1993-December, 1995
Project Manager: Geological investigation of Haopo gold and silver deposit
Supervised and conducted 1:2000 mapping; analyzed ore chemical composition, completed the report of evaluation of potential gold and silver deposit.

Geological investigation of Fanjiabu Gold deposit
Conducted 1:2000 mapping; supervised drilling hole for exploration of gold; collected samples and analyzed chemical composition, wrote gold deposit investigation report.

SCHOLARSHIPS AND HONORS.
- Hebei College of Geology Outstanding Student, 1991.
- University of Texas at El Paso Outstanding Student. 2001
- Third Prize Oral presentation: 19th Annual Colloquium of Geological Sciences, 2004.

ASSOCIATION
American Geophysical Union Geological Society of America

PRESENTATION AND PUBLICATION
Wu Kaiwen and Andronics, Chris L., Structural geology and tectonics of the Franklin
Mountains, West Texas: Geological society of America, abstracts.2002.

Wu kaiwen, the influence and treatment of spherical weathered granitic body to the uprightness of large diameter drilling. Special Paper of 35th Anniversary of Chinese ChangJiang Navigational Engineering Bureau, P. 23-27. 1997.

Wu kaiwen, shi dianzhang and yanglixin, Geological investigation report of perspective Gold and silver in Hapo mining zone. Government document, 1994.

Yang lixin and Wu kaiwen, Geological investigation report of Fajiabu gold mine: Government document, 1994.

View contact information...
«« previous resume next resume »»
Search Results (Resumes 2351 to 2400 of 3489)Go to Search Parameters...
Brief Description
Instrumentation and Control Engineer
Electrical Engineering, Energy Systems, Power electronics
I am Diploma in Mechanical Engineering. I have adequate knowledge in Auto-Cad in mechanical engineering field. I also have confident experience in X-Steel & SDS2 in steel structure back ground.
Graduate Electrical with Power Electronics
B.Com (Commerce, MS-Word, MS-Excel, Tally, Emails, Internet & Other Software
Experienced Reliability Engineer seeks overseas rotational position (i.e. 28/28)
I am graduated with M.Sc.Applied Geology with Specialization in Geophysics. I have completed my Internship with Oil and Gas development company (O.G.D.C) in geophysical data interpretation of oil well. I have also worked on different softwares like Golden software (surfer 8), Didger, QuickSyn.
Prevent / correct unsafe acts & condition.
A Mechanical Engineering graduate from NIT/KREC SURATKAL INDIA with over 19 years of experience in mining sector with over 7 years as Head of Maintenance operation in underground as well as open pit mine.Presently working as SBU head with responsibilities including planning,procurement,budget prep.
An enthusiastic professional with proven ability in software development, from inception to sign off. Excellent software development and technical skills, with experience in PHP, MySql, Access, ASP, ASP.NET, VB6, VB.NET, Microsoft SQL Server, Seagate Crystal Reports and other development tools.
Graduate Engineer looking for work in mining or mineral processing industries.
Over twenty years of experience
Mining Engineer with 20+ years experience, Supervisor of Drilling Crews, great work ethic, will meet deadlines and bottom line, effective team builder
Procurement & Supply Chain Management
Area lead designer, PDS ,Microstation, AutoCad, Smartplant review, Peligan Forge Support moduler.
Seeking Chemist, Laboratory, or Quality Control Position
Worked in an oil and gas industry and undergone an intensive training .
Seeking International, full-time position in Central, South America with a mining company for the development and management of capital projects. Peruvian Residency Available, Spanish, Project Management and Construction Experience with Heap Leach and Tailings Facilities
Presently I am working with a Multinational FMCG Company (Dairy Division)
I have 13 years of experience in,mining and oceanography,i have worked in an institition where i held leading posts and have been able to achieve all the set cooperative startegies in the shortest time as possible
Experienced operating Komatsu 830E and 630 dump trucks. Also CAT 777D dump trucks and water carts. Experienced blast crew. Many licences and quals. Experienced trainer and assessor
Manager / Engineer ( HW/SW/QA/Training )
I have over 20 years in the underground profession and I am looking for some company that can utilize my experience.
Experience with Electrical and Instrumentation & Control Systems design which encompasses project estimating, equipment purchasing, design, build, programming, installation, start-up (commissioning) and field service/troubleshooting for the following: AC motor controls, MCC’s, VFD’s, MOV’s, AOV’s,
Sr.Document Controller
Marine + International Projects Oil & Gas
I am a qualifies Inter provincial (red Seal) Industrial Mechanic (millwright), as well as a Interprovincial (red seal) welder certificate, with a all psition SMAW CWB and a 2 position GMAW CWB ticket.
-1 yr: Business Consult. in Comm. Futures Trading for analysis commodity markets -1 yr & 2 mths: implement, maintain database & filing system -2 yrs: Expl. Geologist working in the field at remote locations, produce maps,maintain database; Sound knowledge of safety policies
PE in Mining, Environmental & Civil Engineering with 26+ years experience in surface coal mining management, engineering & environmental. I've held positions up to and including Vice-President of Operations. Well experienced in open pit dragline & truck/shovel operations. Well organized.
Seeking employment in mining Industry/Consultency as Mine Planning /Scheduling Engineer. Key Skills: Exposure to mechanised Underground and Opencast mining technologies. Experience in Computerised Mine Planning and Geological modelling using Minex software and Autodesk
I am a Technical Design Engineering of 23 years, I work in a manufacturing company of my country. I am interesed in 3D cad modeling, drafting and simulation/animation product base on CAD/CAM/CAE system (AutoCAD, MecDesk, Solidworks, Catia, Unigraphic, Pro/E, Mastercam, Mold flow, Xsteel, etc)
Managing, organising and participating in geological field studies, drilling and geological testing programAnalysing geological, geochemical and geophysical survey data, well logs and other test results, maps, notes and cross sections, core samples, drill cuttings and rock samples
I am a safe and productive Miner with ten years of increasing experience
Quailty Coordinator, Welding Specialist, Safety Training Coordinator, Operations Coordinator Prefer Former CIS Russia, Kazakhstan
Professional Qualifications: BE Sales & Marketing Open, City & Guilds Mechanical Technician,ONC Pipe Maintenance & Instillation,NVQ Level I, II, III Quality Auditing,Diploma supervisory management Team Leadership I & II,
Surgical Emergencies :- Road Traffic accident, crush injuries, blunt trauma abdomen,Head injury, liver tear, gunshot, spleen rupture, face injuries, stab injuries, spinal cord compression, assult injuries, burn injuries etc.n Medical Emergencies :Myocardial Infraction, COPD, sun stroke, snake etc.
Corporate Executive in Information Technology with extensive international experience in Systems/Product Architecture (Analysis & Design), Program/Project Management, Business Continuity Disaster/Recovery Planning, Technical Service Delivery & Support, Technical/Operations Management
Contract data analyst specializing in data extraction, conversion and reporting for over seven years.
Troublshooter, computer and networking, electronics, technicial
Drilling and blasting Engineer-
Iam a Zambian aged 25 and Iam looking for employment in the Purchasing and Supply Department.
Seeking Position in Oil Industry.
My two and a half years experience working in the mining atmosphere in the Morenci Mine repairing and maintaining CAT equipment and haul trucks coupled with my interest and passion for heavy duty mechanics will hopefully align well with what you are looking for.
I am Professional Logistician (CITT), Certified Purchaser, Journeyman H/D-Parts Technician and Warehouseman. I live and work in Fort McMurray (Warehouse Supervisor for Nexen Canada at Long Lake Project ($21 million inventory) -20 years of combined material distr.experience
Geologist mining, environmental company
Powerbuilder, Sybase, Oracle, Informatica, UNIX Shell Script & Perl technical skills as Analyst Programmer.
Have exstensive experience, training, and knowledge as an underground coal mine Maintenance Foreman/Electrician in longwall and continuous miner sections. Have excellent electrical, mechanical and hydraulic skills along with welding,cutting, and fabrication skills.
Diamond driller / Truck driver
Experienced offshore Client Representative and qualified Hydrographic surveyor; with Master's ticket, NEBOSH, MCSE .
Project Management / Inspection / Procurement / Quality Assurance
First   1   2   3   4   5   6   7   8   9   10   11   12   13   14   15   16   17   18   19   20   21   22   23   24   25   26   27   28   29   30   31   32   33   34   35   36   37   38   39   40   41   42   43   44   45   46   47   [ 48 ]   49   50   Next   Last
Seach Parameters

Change search parameters...
INDUSTRIES: Mining;
Change search parameters...
Keywords: (e.g. mining engineer)Find results with:
Save this search parameters...
Post job with this search parameters...
Frequently Asked Questions
What's the most effective way to perform a search?
Go to Advanced Search
1. Select 'Industries', 'Categories', 'Education', and 'Experience' fields. Click 'Search' and look through results.
2. Enter one or two of the most important keywords. Click 'Search' and look through results.
3. To search within results add more keywords.

How can I find resumes that contain specific exact phrase?
To search for an exact phrase, just put quotation marks around two or more words, for example "mining engineer". Use this feature to narrow your results or to find words that can be typed differently, for example AutoCAD "Auto CAD".

More Frequenly Asked Questions...
Employer's Center


» Employers Home
» Feedback
» Help

» Post Jobs
» Edit/Delete Jobs
» Search Resumes
» Resumes By Email

» My Account
» Log In

» Log Out
 
©1999-2009 Misco Jobs. All rights reserved.  Contact: support@miscojobs.com