Resume - Process Engineer, having 2 years of experience in Oil and Gas sector, working in...

Misco Jobs

Resume #72533

CONTACT INFORMATION:
View contact information...

CURRENT EMPLOYER: LARSEN & TOUBRO LTD, BARODA.

Department Front End Engineering Design (FEED)
Designation Process Engineer
Experience 2 years

NATURE OF RESPONSIBILITY

* Preparation of Process / Basic Engineering Package
* Carry out Design Verification and Design Analysis of FEED package
* Contribute to development activities of the department
* Provide commissioning and trouble shooting assistance
* Provide Process & Project Engineering Services to Refinery & Petrochemical SBUs

PROJECT INVOLVEMENT

. Design verification and Process Engineering support for the Proposals and Projects to Petrochemical & Refinery SBUs.

* Involved in Sulphur Recovery Unit Bina, M.P. Proposal
. Performed simulation of Sulphur Recovery Unit (SRU) and Tail Gas Treatment Unit (TGTU) using HYSYS & SULSIM
* Performed check rating of the Heat Exchanger of SRU using HTRI software.
* Involved in Consistency Check between various documents like PFD, PID, PDS & MDS.

* Involved in Sulphur Recovery Unit Baroda, Gujarat. Proposal
* Performed simulation of Sulphur Recovery Unit (SRU), Amine Recovery Unit (ARU) and Tail Gas Treatment Unit (TGTU) using HYSYS & SULSIM
* Performed check rating of the Heat Exchanger of SRU using HTRI software.
* Involved in Consistency Check between various documents like PFD, PID, PDS & MDS.

* Involved in MG3 Refinery, Malaysia, Project
* Involved in PFD, PID review, Consistency Check between various documents like PFD, PID, PDS & MDS.
* Involved in engineering coordination during engineering phase.
* Performed system identification for Pre-commissioning and Commissioning.

*Department Capability development & Skill building in Basic Engineering

. Prepared a Clause Sulphur Recovery model on HYSYS Dynamic Simulation.
. Preparing an integrated system for Projects and Proposal on ASPEN ZYQAD.
. Developed a Basic Engineering Package on Sulphur Recovery Unit (SRU) and Tail Gas Treatment Unit (TGTU) for the 2 x 300 TPD capacity. This included
* Process selection from different process alternatives
* Process simulation using SULSIM, HYSYS
* Process Equipment Design viz. Heat Exchangers, Columns, Vessels
* Prepartion of conceptual plot plan, Process Flow Diagram, Process & Instrumentation Diagram and Material of Construction Diagram
* Line sizing by Pipeline Hydraulics and Pump Hydraulics
* Process control philosophy and provide interlocks & trips using HAZOP study and Cause and Effect Matrix.
. Prepared technical study report on Sulphur Forming and Handling

Exposure to Design Software /Process Simulation Software: HYSYS steady state, HYSYS Dynamic Simulation, ASPEN PLUS, SULSIM

Equipment Design / Rating Software: HTRI, HTFS+, KG TOWER,

ACADEMIC QUALIFICATIONS

POST GRADUATION

M.Tech. CHEMICAL
Spec.: Industrial Pollution Abatement
University / Institute Indian Institute of Technology (IIT), Roorkee
Month & Year of Completion June - 2006
CPI Obtained out of 10 8.73

GRADUATION

B.Tech. CHEMICAL
University / Institute Bundelkhand Institute of Engineering & Technology, Jhansi
Month & Year of Completion June - 2002
Agg. Percentage in final year 70.48 %

SCHOOLING

CLASS SCHOOL BOARD PERCENT DIVISION
12th R.J.P Araya Inter Collage, Bijnor U.P. 71.8 I - Dist
10th Islamia Inter Collage, Bareily U.P. 66.7 I - Dist

M.TECH. FINAL YEAR PROJECT

Topic of Dissertation: Filtration of Suspended Particles: Design, Analysis and Simulation.

EXTRA CURRICULAM ACTIVITIES /ACHIEVEMENT

* 95.93 percentile scored in "Graduate Aptitude Test in Engineering (GATE)-2004" and awarded by AICTE-MHRD Scholarship.
* Actively participated in All India Petrotech meeting held at Delhi, India in 2006.
* Regular cricket team member for L&T cricket team XAVERI.
* Active member of Cultural committee during B.Tech.
* Regular B.Tech. Cricket team member and won best batsman trophy in 2002.

If you don't have a resume use the following information below as a template.

SUMMARY OF QUALIFICATIONS:
------------
Proces Engineer having Master Degree in Chemical Engineering From IIT ROORKEE

OBJECTIVE:
------------
Process Engineer job in Oil and Gas Sector.

WORK EXPERIENCE:
------------
CURRENT EMPLOYER: LARSEN & TOUBRO LTD, BARODA.
Department: Front End Engineering Design (FEED)
Designation: Process Engineer
Experience: 2 years

EDUCATION & CERTIFICATION:
------------
95.93 percentile scored in "Graduate Aptitude Test in Engineering (GATE)-2004" and awarded by AICTE-MHRD Scholarship.

ADDITIONAL INFORMATION:
------------
* Actively participated in All India Petrotech meeting held at Delhi, India in 2006.
* Regular cricket team member for L&T cricket team XAVERI.
* Active member of Cultural committee during B.Tech.
* Regular B.Tech. Cricket team member and won best batsman trophy in 2002.

HOBBIES
Reading books; Watching & Playing cricket, football & Volleyball; likes to travel

View contact information...

«« previous resume

next resume »»

Search Results (Resumes 2201 to 2250 of 6411)

Go to Search Parameters...

Brief Description

Detail engineering

Electronics & Mechanical Engineering with QA/QC certification

Diploma of Associate Engineer In Electronics Technology(Supervised two shut-down at PARCO refinery in 2002, 2007 & my scope of work covered, Control valves, Compressor, Steam Turbine & high pressure Pumps instrumentation removal, overhauling, calibration check, reinstallation and start-up sport)

Having eleven years experience in field of Oil , Gas & Petrochemical industry

Diploma Mechanical engineer + CSWIP 3.1 + NDT ASNT lev II + ACAD + P3

Passed Matriculation from Bombay Board in English,:Passed Diploma from Kohinoor Technical Institute in Industrial-Elect, Two years course.Attend Safety Training in QATAR GAS, SABIC,ADNOC . HSE Induction,H2S Awareness and Escape. Received Safety Award Certificate from ADNOC on its ongoing projects.

Bachelor of Electrical Engineering [BE] : 5 Years Hands On Experience in Power Utility Company in Medium and Low Voltage System Operations and High voltage 132KV/11KV Substation Protection Systems

Process Engineer, having 2 years of experience in Oil and Gas sector, working in FEED department. Having exposure to Process Simulation tool like HYSYS STEADY STATE HYSYS DYNAMIC SIMULATION, ASPEN PLUS, SULSIM and Equipment Design/Rating Software like HTRI, HTFS, KG TOWER, and SULCOL.

I am presently employed with Black&Veatch, a US based reputed company doing mainly Oil &Gas and EPC projects mainly in power plants.

Process engineer with two years of experience in the feild of basic enginnering, front end engineering design and precommissioning and commissioning of process plants.

Provide day to day on-site supervision of drilling operations to ensure operations are performed in accordance with the Drilling Program in a safe cost-effective manner.I m responsible for Health and Safety procedures being continuously enforced

Development, maintenance and utilization of the full field reservoir simulator

I am an enthusiastic and professional Marine Engineer / Plan Maintenance System Engineer, working with AMOS and RAST Programs. I am quick to grasp new ideas and concepts, and to develop innovative and creative solutions to problems.

Total Exp. 2 years. Exploration, Drilling, Workover - offshore and onshore wells. Estimating cost of oprn., coordinating with service providers, supervising drilling operations.

PLC programming, installation and commissioning of motor drives/ process controller and instruments and have expertise in board-level repair of electronics controls and PC board.

•Leadership Quality,•Loyalty with the assigned responsibility,•Decision making •Desire to produce better results than previousability,

Drilling supervision and engineering, well control instructor, rig commessioning

Reservoir Engineer, B. Tech (Petroleum Engineering), 11+ years in reservoir simulation studies, development planning, performance review, well equipped with most of analytical aspects

Mechanical/Piping Engineer with 13 years experience in offshore industry looking for new challenge. Good communication, organisation skills. Team player. Good knowledge of piping and mechanical codes and standards, Caesar II, PV Elite, CodeCalc.

10 years experience in the oilfield Drilling and well services both on offshore and land rigs. Field Engineer experience performing installation and trouble shooting of drilling equipment.

SOECOR Reservoir Engineer. Offshore oil well geophysical log analysis Schlumberger), testing and evaluation. On site project work in conjunction with engineers and geologists. Geohydrological investigations in South West Africa (Namibia).Geophysical investigations.

FIELD PIPING ENGINEER - OIL AND GAS ONSHORE / OFFSHORE LEAD PIPING DESIGNER, CHECKER

Senior Piping Designer-Office & Field.Multi-industrial background: Experience in Food & Pharmaceutical, Petrochemical, Power (Nuclear & Fossil), Semiconductor (Clean Room) & Steelmaking as well as working for Consulting Engineers & Piping Contractors.

TRAINING OF DRILING LANGUGES SKILLS FRENCH. ARABIC. ENGLISH AND LETARATE OF COMPUTER WORD AND EXEL AND IERNET

Credential 9 years functional experience in Oil & Gas Engineering construction project and nine years in explosive department of Govt. of India.

I am a post graduate process engineer with over three years of experience in Oil and Gas and Petrochemicals. I have worked for FEED as well as detailed engineering in EPC and consultancy environment. I am familiar with process simulation as well as design softwares such as HYSYS, HTFS, FLARENET.

Project Management

Project Engineer :Responsible for execution of assigned projects from proposal to detail design completion.Responsible for ensuring that the package for submittal to the client meets all client requirements.

Specialist In DCS, P LC, SCADA, Turbines, Control & Instrumentation

22 yrs of experience in Govt of India, engineering consultancy firm (An ISO 9001 Company) and has wide exposure from basic engg to detailed engg of multi disciplinary mega projects related to Water and Environmental engineering, Infrastructure, Heavy Industry, Oil & Gas, Urba

SENIOR PIPELINE ENGINEER- OFFSHORE- SEVEN YEARS OF PROFESSIONAL EXPERIENCE IN DESIGN RELATED TO ALL ASPECTS OF CONCEPTUAL, BASIC AND DETAILED ENGINEERING OF SUB-SEA AND ONSHORE PIPELINES IN OIL & GAS INDUSTRIES BASED ON DNV RULES, BS 8010, ASME B 31.4. B 31.8 AND B 31.3 CODES.

Senior Piping Designer PDS

Refinery operator, panel operator, start-up all units in oil industry, 20 years in refinery industry.

Rig mechanic, mechanic supervisor, motorman, diesel mechanic

Offshore Survey - Client Representative, Project Surveyor, Party Chief, Engineer

Mechanical Maintenance Engineer/contract and Procurement Engineer

Worked for several drilling companies, service and maintenance organizations during my career. Managed large numbers of personnel in most of these companies. Known for effective time and cost saving procedures. Excellent safety record, proficient in human relation skills, self-starter, task orientat

QA/QC Engineer with more than 16 years in engineering & construction, from medium to large projects. exposed to oil & gas projects, onshore projects, industrial and building projects.

Quality engineer in offshore and onshore fields

Senior Instrument / Control & Automation Engineer for all phases of project execution (FEED, detailed design, procurement, construction supervision, commissioning assistance, handover to operation). 12 yrs offshore & onshore E&P oil & gas exp. (FFB, DCS, IPS, PLC, F&G, BN, Remote I/O, AS-i Bus)

Registered Mechanical Engineer Cert. No.61058,CSWIP 3.1 Cert. No.35530

Electronics Technician / Telecom / SATCOM / Electronic Tools

Specialised in PROJECT & PRODUCTION MANAGEMENT ,QUALITY , MANUFACTURING, HSE

Proficient in CAESAR II, Korf Hydraulics, AutoCAD, Primavera and MS Office.

ESSAR OIL LTD- FCCU (May 2005 to May 2008)

18 years in field operations, management, production engineering, gas processing. tight formations, CBM and shales.

B.Eng(Petroleum Engineering);Diploma(Object-oriented/Scientific programming);Experience in Cementing, Stimulation(CT/N2 jobs),Completions fluids/Wellbore clean-out tools

Production & Quality professional with five years of experience in chemical & petrochemical plants, working with multicultural people in a team environment.

Petroluem Engineering

Mechanical / Static / Pressure Vessel Engineer (~5 Years Oil & Gas Experience)

First 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 [ 45 ] 46 47 48 49 50 Next Last

Seach Parameters


Change search parameters...
CATEGORIES: Engineering/Technicians; INDUSTRIES: Petroleum/Oil/Gas;
Change search parameters...
Keywords: (e.g. mining engineer)		Find results with:


Save this search parameters...
Post job with this search parameters...

Frequently Asked Questions

What's the most effective way to perform a search?
Go to Advanced Search
1. Select 'Industries', 'Categories', 'Education', and 'Experience' fields. Click 'Search' and look through results.
2. Enter one or two of the most important keywords. Click 'Search' and look through results.
3. To search within results add more keywords.

How can I find resumes that contain specific exact phrase?
To search for an exact phrase, just put quotation marks around two or more words, for example "mining engineer". Use this feature to narrow your results or to find words that can be typed differently, for example AutoCAD "Auto CAD".

More Frequenly Asked Questions...

Employer's Center

» Employers Home

» Feedback

» Help

» Post Jobs

» Edit/Delete Jobs

» Search Resumes

» Resumes By Email

» My Account

» Log In

» Log Out