CONTACT INFORMATION:
View contact information...
Sex: Male
Place / Date of Birth: Jakarta, September 19th 1973
Marital Status: Married
Religion: Moslem
Nationality: Indonesia
Hobby: Sport, Reading
Profession: Foreman
Current occupation: Steam Generation Foreman for Tans Pacific Petrochemical Indotama
II FORMAL EDUCATION
1987 – 1987: Elementary School, SD Negeri II Rimbo Bujang, Jambi
1987 – 1990: Junior High School, SMP Negeri V Pariaman, Sum-Bar
1990 – 1993: Senior High School, SMA Negeri I Pariaman, Sum-Bar
2000 2001: Oil and Gas Academy, Blora Jawa tengah
III WORK EXPERIENCE
PT. CHANDRA ASRI PETROCHEMICAL CENTER (CAPC)
As Operating Technician in Production Department 1.2 – Utility Section from December 1st 1993 until February 18th 2001
QATAR PETROCHEMICAL COMPANY
As Utility Outdoor Operator from February 18th 2001 until April 21st 2003
TRANS PACIFIC PETROCHEMICAL INDOTAMA
As Utility DCS Operator from February 01, 2005
IV JOB TRAINING AND COURCES
1.Pre Employment for Petrochemical Plant Operator in Polytechnic Education and Development Center – Institute of Tehnology Bandung (ITB) from December 1st 1993 until May 31st 1994 in Bandung, West Java.
2.English Special Purpose. Training Programe by LIA Language Institute, Jakarta from June 1st until August 31st 1994 in Cilegon, Banten
3.Utility System Classroom Training Programe by PD I,2 – Utility Operation Staff of PT. CHANDRA ASRI PETROCHEMICAL CENTER in Cilegon, Banten. Certificate on June 15th, 1994
4.Training Program for Utility / Off Site Facilities for CAPC Olefin Project by Vendor at site – Anyer, Banten. Certificate on 1994
5.Operation Training for Water Clarification, Filtration and Demineralization Plant by PT. Nalco Perkasa in Cilegon, Certificate on August 11th, 1994
6.Training for First Aid conducted by Qatar Petroleum Umm saieed, Doha state of Qatar
V JOB SPECIFICATION
Utility Facility & System in PT. Chandra Asri Petrochemical Center, Qapco and TPPI are as follows:
1.Water Treatment Facility:
Pre Treatment Unit, Demineralization Unit, Polisher Unit, Sea Water Desalination Unit, Chemical Injector Unit, Sludge De Watering Unit, Chlorinator, Tank, Filter Pump, Steam Turbine, Pit / Basin and Crane
2.Sea Water Intake Facility:
Pit / Sea Water Intake Pit and Pump Basin, Filter / Sea Water Screening Unit, Electro Chlorination Unit, Pump, Steam Turbine, Chemical Injection Unit, Silencer, Heat Exchanger and Crane
3.Cooling Water Facility:
Heat Exchanger, Storage Tank, Pump, Steam Turbine and Chemical Injection Unit.
4.Steam Generation Facility:
Aux Boiler (1 X 90 T/h), Heat Recovery Steam Generation/HRSG (3 X 75 T/h) manufactured by PT. DKME.
Boiler feed water pump with capacity 3 X 250 T/hr, 2 turbine and 1 motor driven
Steam condensate system
Deaerator and accumulator drum with capacity 585 T/hr
Steam letdown station (HP-MP-LP) with pressure 43 Kg/Cm2, 17 Kg/cm2 and 3.5 Kg/cm2.
5.Power Generation Facility:
Combustion Turbine Generator, 3 X 21 MW, Type MS 5001, manufactured byNuovo Pignone, ItalyEmergency diesel generator, manufactured by PT. Trakindo with capacity 3 X 1.5 MW
Fuel Oil and Fuel Gas System. Fuel Gas Booster Compressor, manufactured by MAN Turbo with capacity 2 X 9 T/h
6 Air Supply System
Vessel, Dryer, Compressor, Boiler
7.Fuel Supply System
Heat Exchanger, Vessel, Tank, Pump
8.Waste Water Treatment Facility:
Oil Separation Unit, Equalization Unit, Neutralization Unit, Air Floatation Unit, Biological Treatment Unit, Sludge De Watering Unit and Incineration Unit Rotary Kiln for Emulsion and Final Check Basin.
9.Fire Fighting Facility:
Vessel, Tank, Pump and Diesel Engine.
VI. JOB RESPONSIBILITIES
Responsible for proper operation of the process and equipment that is within my assigned area.
Responsible for house keeping and maintaining my assigned work area in a safe condition.
Incorporate safe work practices and procedures that will protect my self, others and the equipment.
Take an active interest in maintaining effective log sheets pertaining to the operating temperature, pressure, flow vibration, etc, that is critical to the process and equipment.
Communicated to supervisors when the process or equipment that are under my responsibility began to deviate from the normal mode of operation.
Responsible for isolation of equipment according to the established safety standard and work procedures.
Responsible for signing Work Permit signifying that all equipment within my assigned area has been properly prepared for commencement of the Work Permit activities.
Work with the Lead Operator, Maintenance Personnel, est. to resolve day to day.
Will always be required to shut down and start up unit processes and or well sites
Under the direction of this immediate supervisor.
View contact information... |