Resume - Dec 2002 Shift/ - Board Supervisor. Jan 2002 – Sept 2002. Shift Team Leader / Pa...

Misco Jobs

Resume #5164

CONTACT INFORMATION:
View contact information...

Objective To work with a major Oil Refinery that incorporates expansion and safety with the opportunity for future enhancement.

Experience Dec 2002 – Present. Coastal Aruba Refining Co. / El Paso, Aruba Shift/ - Board Supervisor. In charge of running the HDS Area Complex and two drum Delayed Coker unit on the TDC 3000. Also responsible for the training and guidance of new panel board operators.

Jan 2002 – Sept 2002. F.W.P.S. S.A.E. Free-zone El Amreya Egypt
Shift Team Leader / Panel Trainer. Working experience and up to September is at the state of the art
MIDOR refinery in Alexandria – Egypt. There I have worked as shift panel board trainer. My duty was to train the local board operators in trouble shooting from the DCS system, and assist the S.T.L in their busy routine job.

June 2001 – Dec 2001 Sincor upgrade refinery Anzoatequi, Venezuela
Start-up - / Shift Team Leader. There I was working in the positions of S.T.L in the Foster Wheeler Delayed Coker Unit with 6-drum. My duty was revise unit start-up procedure and to perform training to the unit operating crew.

Nov 1991 – June 2001 Coastal Aruba Refinery Co, N.V Aruba W.I
Panel Board Operator and Lead Operator. Working experience at the Coastal Aruba Refinery Co N.V. There I worked as lead operator and panel board operator on a 2 units 2-drum Delayed Coker and on the Hydro-Desulphurisation unit's complex. Performed all operating task and insured safe and effective operation conditions as per area Superintendents guidelines on the following unit's.

History. 2 Delayed Coker Units with a capacity of 32 & 38 kb/d. 3 Hydro-Desulphurisation units with a capacity of 60-75 kb/d and 80 kb/d. Kero Hydro-finer unit with a capacity of 50-55 kb/d. 2 Sulphur recovery units with a capacity of 200-250 kscf/hr each. Vacuum units with a capacity of 175 kb/d. Diesel Hydro-finer unit with a capacity of 65 kb/d. Mea / Mdea regeneration units with a capacity of 1000-1100 kb/d. Sour water stripper recovery unit. Hydrogen purge gas recovery unit with 2 (2 stages) compressor. Liquids propane unit. Flare facilities system in the Hydro-desulphurisation complex. Steam condensate recovery unit. Refinery fuel gas H2S removal system with 2 reciprocating compressor. Also worked as shutdown and start-up coordinator on all the above mention units.

Education 1982–1986 John F. Kennedy Technical school Aruba, W.I From 1982 to 1986 John F. Kennedy Technical school, Completed technical level in electrical and Mechanical Theoretical trade level.
1986-1991 ING: Cesar Terzano Technical School. Completed a secondary technical level school with civil engineering degree theoretical trade level, with English, Spanish and Dutch as main languages.

Interests Flight Simulator, Gardening, Computers.

Tips Refinery Courses: John Zink combustion Co. in heaters troubleshooting, Criterium Catalyst Co. In catalyst handling and loading. Betz Chemical Co. in boiler feed water treatment. Chem-link Co. in boiler feed water treatment and condensate. ABB-LUMUS course in Delayed Coker knowledge's. Basic Refinery Operations training qualified gas tester and safety inspection training from CARC & Osha advance process control from Honeywell on TDC – 3000 and Foxboro DCS control system.

View contact information...

«« previous resume

next resume »»

Search Results (Resumes 6801 to 6850 of 10924)

Go to Search Parameters...

Brief Description

I have a stable work history having spent four years working as a Mechanical Engineer within the Teyseer Group in Qatar. I have a broad range of experience including project management, site and field works, tender preparation, etc. On Sep 2004, I graduated as a Petroleum Engg (Masters Degree).

Over 15 years experience as a instrumentation & control engineer in oil/gas , petrochemical industries. For the past seven years , I have been also involved in SCADA system in detailed basic engineering, integrating, commissioning and maintenance.

I am candidate who has excellent research and development skills along with good manufacturing experience.

Dec 2002 Shift/ - Board Supervisor. Jan 2002 – Sept 2002. Shift Team Leader / Panel Trainer. June 2001 – Dec 2001 Start-up - / Shift Team Leader. Nov 1991 – June 2001 Panel Board Operator and Lead Operator.

Civil engineering graduate with 13-years of professional working experience as a Senior Document controller in gas and oil industry. A computer literate, familiar with EDMS, QVP and Plantdoc programs used in project documentation.

Profile Total of 6.5+ years of IT experience with 5.5+ years of SAP R/3 experience in ABAP Programming in the functional areas of MM, SD, PP, PM, FI & Payroll.

Proficient in physical and wet chemistry analyses using gravimetric, titrimetric, and spectrophotometric techniques. Computer Software knowledge in HYSYS,MAPLE, ASPEN, HP Chemstation, Microsoft Office, Microsoft NT.

Petroleum Engineer with 6+ years of experience in the Oil & Gas Industry. Specifically in Middle/Heavy Oil. Strong Knowledge in Production Asset Management, ESP and Gas lift Design and Operations, Horizontal and conventional wells, Cyclic Steam Injection and New Technologies for E&P Industry.

Certificates in H2S Alive, W.H.M.I.S., and class 5 airbrakes. Work history includes warehouse work, shipping and receiving, loading and unloading trucks, driving forklifts and pallet drivers, and customer service

Post Applied Document Controller

Main job is Seismic Processing Analyst The main Projects 2D, 3D (land &marine), AVO All Projects works include; pre-stack processing, post-stack Processing ,and migration(PSTM_some Projects) ,Velocity Analysis AND build modules , finalizing these projects by writing the processing reports

Geologist looking for employment in the Oil Industry

Training for Entry Position for Oil and Gas Industry (Floorman), Engineer Degree for Fisheries, Experience working for Major Projects and at the Sea, ourdoors and long hours

I am full confident about the any job of analyzer/instrumenation for detail see my resume

Good research aptitudes intellectual, potential and creativity.

Mechanical Designer Engineer

Profesional Employer with International acknowledge Certification

A Highly Motivated, Vastly travelled and Adaptable Drilling Specialist With over 25 yrs of on/offshore experience – Africa, Middle East and South East Asia – who offers: Expertise in drilling rigs operations, support and mgt; well engineering, HSE coordination; Training, HR mgt & Recruiting.

A Health, Safety & Environment (HSE) Professional with more than 12 years of extensive working experience in Oil & Gas Onshore & Offshore Project, LNG Construction, Commissioning & Start Up.

Senior Instrumentation and Controls Technician

Shaped Charge Engineer

Instrument supervisor / technician v exp construction commissioning start up HSE

I have 30+ years experience as a Mud Engineer, 18 years International experience. I have held positions as Country Manager, Ops. Manager, District Coordinator and Fluids Coordinator. I am experienced in all types of Water/Oil/Synthetic based fluids, Silods control and waste disposal.

Navigational skills, Stability, Mangement

Around 8.50 years experience in Electrical/Instrumentation Engineering and Maintenance in the Industrial sector, extensive experience in end-to-end execution of EPC Projects including supervision of Installation, Calibration, Testing, Pre-commissioning, Operation and Maintenance of Plant Instrumenta

I'm Tommon Mathew working with mott macdonald as a project engineer in oman for various oil and gas projects.

Obtain above position in fast growing IT organization offering challenge, responsibility and advancement opportunities while utilizing my best skills in System administration

Bachelor of Agriculture Science (Honors): 1995-1998 Major in Economics U of A, Excellent communication, trouble shooting skills and professional knowledge gained through interaction with public and running own business for the past 3 years.

EDUCATIONAL QUALIFICATION:DIPLOMA IN CHEMICAL ENGINEERING,job at present: SOHAR REFINERY COMPANY LLC, SOHAR, MUSCUT, OMAN,and actively involved in precommissioning and commissioinig activities.i have total 11+yrs of experience in refinery/petrochemical industries.

Electrical Resistivity geophysical investigation (ABEM Terrameter SAS-300), Topographic Survey (SOKKIA SET 5F), Global Positioning System (GARMIN), GIS

Autocad & Inventor Draftsman

I am an instrumantation and control system designer working with FLOUR INDIA , I am a Diploma holder in Electronics engineering , my working exprience is 03 year

Application for QA/QC Inspector job (Ready to work Offshore)

A Well Services company manager with almost 30 years of industry experience; my background includes working in the oilfield service sector with numerous postings in Canada, Russia, China, and New Zealand. Working with teams of talented people to achieve exceptional results is foremost on my list of

Effective knowledge and working with Microsoft windows based software like MS Office (word, Excel, PowerPoint) as well as in AutoCAD.

Management consulting professional with global consulting experience. Proven track record in executing strategy and operations consulting assignments. MBA, CFA Level II Candidate

I have experience on land drilling rigs and would like to obtain an offshore position.

I have completed a 2 year diploma program in electrical engineering technology. I graduated with honours because of my hard working and dedicated attitude.

Petroleum Landman and Abstractor.

Camp Attendant / General Help/ Administration

I am diploma marine engineer Working in Amsa Total solutions Pvt Ltd., as Quality Control for the past three years. I have completed AWS-Certified welding inspector. I have also completed SMAW -4G Welding course. I'm dedicated & highly motivated to accept challenges & pursue perfection in work

A skilled technical professional with influential leadership and management skills. Proven ability to work in the office and work in the field.

B.E. Petroleum, Working in Workover Department

Exploration, Development, Workover, Deviated Well Drilling Supervisor

I'm a Registered Electrical Engineer and experienced Safety Officer for more than 10 years. Presently am working with a US based Drilling Company as Offshore Rig Based Safety Officer in Saudi for their offshore project. I hope with my experience and initiative, I would be able to contribute positive

Professional Geologist with petroleum exploration and hydrogeological environmental experience

Project Manager, Mechanical Engineer with 20 years experience in Gas Turbine Industry

To seek a position that maximizes my knowledge and technical expertise in the field of Petroleum Engineering & technology, Electronic mechanic, Computer system application, electronic device assembly and trouble-shooting, Design & process engineering.

Offshore Field Engineer with 2 years experiance in shypyard and 3 years onshore/offshore.

Degreed Petroleum Engineer, Production, Workover, Completion, Planning, Programming, Procedure Writing, over 20 years hands-on experience, Field Supervision, Mentoring Local Staff, Excellent Communication and Human Skills, Good Overseas exposure, Adaptable to most current software and applications.

First Prev 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 [ 137 ] 138 139 140 141 142 143 144 145 146 147 148 149 150 Next Last

Seach Parameters


Change search parameters...
INDUSTRIES: Petroleum/Oil/Gas;
Change search parameters...
Keywords: (e.g. mining engineer)		Find results with:


Save this search parameters...
Post job with this search parameters...

Frequently Asked Questions

What's the most effective way to perform a search?
Go to Advanced Search
1. Select 'Industries', 'Categories', 'Education', and 'Experience' fields. Click 'Search' and look through results.
2. Enter one or two of the most important keywords. Click 'Search' and look through results.
3. To search within results add more keywords.

How can I find resumes that contain specific exact phrase?
To search for an exact phrase, just put quotation marks around two or more words, for example "mining engineer". Use this feature to narrow your results or to find words that can be typed differently, for example AutoCAD "Auto CAD".

More Frequenly Asked Questions...

Employer's Center

» Employers Home

» Feedback

» Help

» Post Jobs

» Edit/Delete Jobs

» Search Resumes

» Resumes By Email

» My Account

» Log In

» Log Out