Resume - Electrical Engineering, Energy Systems, Power electronics

Misco Jobs

Resume #81206

CONTACT INFORMATION:
View contact information...

OBJECTIVE
Seeking a challenging full-time Energy Engineering position that utilizes my education and technical skills.

EDUCATION
* State University of New York (SUNY) at Buffalo
* Master of Science, Electrical Engineering, May 2009
* Achieved 'A' grade (4.0/4.0) in all courses taken during second and third semester including multiple courses in the area of Microelectronics.
* Teaching Assistant, Introduction to Nano Electronics
* Awarded Teaching assistant-ship and stipend for academic excellence.
* Conducted classes to assist students perform better in the course.
* Prepared course material and graded assignments.
* Anna University, India
* Bachelor of Engineering in Electronics and Communication, May 2006
* Achieved top results in courses like advanced electronic circuits, electric circuits, Mobile Cell.

SKILLS
* Programming Languages: Verilog HDL, C.
* Hardware Design Tools: Cadence, SPICE, Xilinx ISE, ModelSim, HFSS, Spectrum Analyzer, MAGIC7, Auto CAD.
* Strengths: Computer Architecture, Digital Electronics, Analog Circuits, Integrated Power Electronics.

ACADEMIC PROJECTS
* LED Driver and Photo receiver [Analog Circuits, SPICE]
* Designed, laid out and simulated a chip for fabrication that drives an LED and detects the received light signal.
* Voltage Controlled Oscillator was designed to drive a particular led specification.
* Designed a High Gain Amplifier with low power consumption to detect the received light signal.
* Implemented a Detection Circuit to trigger an alarm above a reference voltage.

* Electronic Security System [Verilog, FPGA, Xilinx]
* Designed and Burnt a FPGA combination lock circuit for security systems.
* Implemented the logic in Verilog using Xilinx ISE 10.1 and tested simulations on ModelSim.

* ASIC Multiplier and Accumulate Unit [VLSI,Cadence]
* Designed, laid out and simulated an ASIC CMOS based Multiply–Accumulate circuit using Cadence SpectreS in 0.6 micro meter technology.
* Implemented the Modified Booth Algorithm and obtained substantial gain in calculation time.

* RF Microwave Research [Spectrum Analyzer, HFSS]
* Independently involved in research by conducting experiments to study the mode conversion in RF microwave waveguides. Cut-Off frequencies in spectrum analyzer were compared with HFSS.
* Comprehensive research and study was performed on various components and equipments like antenna, dielectric material and waveguides.

PROFESSIONAL EXPERIENCE
Engineer I, Larsen and Toubro InfoTech LTD, India June 2006 - July2007
* Designed, Developed and provided technical support for Migration management system.
* Worked, interacted with Freescale Semiconductor and other clients for system requirements and specifications. Fixed multiple production problems in record time.
* Received an award for outstanding performance and growth.

EXTRA CURRICULAR ACTIVITIES
* Vice President, Electrical Engineering Graduate Student Association at SUNY, Buffalo.
* International Student and Scholarly Services Orientation Volunteer, August 2008.
* Volunteer Assistant to fellow student with a disability, fall 2008.

View contact information...

«« previous resume

next resume »»

Search Results (Resumes 9151 to 9200 of 10917)

Go to Search Parameters...

Brief Description

Familiar with all steps of equipment, structure fabrication and piping installation as pertinent specification, document control, subcontractor management knowledge, claim representation and site safety conception.

Diverse technical back ground including hydraulic power plant technician ,fresh water analyst, pump mechanic, maintenance coordinator, maintenance mechanic, and valve installation repair

Draughtsman

Available Immediately To Discuss A Challenging And Responsible Position Where My Background And Experience Can Be Fully Utilized To Our Mutual Benefit.

I am an Electronic Engineer and I have a short experience in Oil & Gas field. My dream is to get an entry level position in this field especially in instrumentation field.

I am a hardworking and honest person looking to have a new career in the oil industry. I am dedicated to my work and would be a good employee.

Pip in indistrial safety, working in ministry of elec & water ,kuwait.

Computer Technician

Principal Environmental & Safety Consultant, oil, gas, mining & major projects; EIA, EMS, Environmental risk etc, climate change, HAZOP, HAZID, Safety managment etc experience. Relocating to Vancouver. Has right to live and work in Canada

Cad Drafter/Designer

Automobile related

Mechanical Engineering Graduate EIT - experience at underground mine sites, maintenance planning, drafting in autodesk inventor, physical asset management, underground mine hoist ropes and lubrication, scheduling

Eight years of experience in the field of Mechanical Engineering Works that primarily concerns on overall mechanical system and details design as well as fabrication.

Instrumentation and Control Engineer

Electrical Engineering, Energy Systems, Power electronics

I am Diploma in Mechanical Engineering. I have adequate knowledge in Auto-Cad in mechanical engineering field. I also have confident experience in X-Steel & SDS2 in steel structure back ground.

Graduate Electrical with Power Electronics

Sub.: Power plant /Utility Electrical Maintenance Engineer

B.Com (Commerce, MS-Word, MS-Excel, Tally, Emails, Internet & Other Software

Shipping Supervisor

Pipefitter with supervisory and training facilitator experience

Experienced Reliability Engineer seeks overseas rotational position (i.e. 28/28)

At present doing a 2 year contract at a bulk fuel installation, in Basrah, Iraq, as an Operator. I have 25 years experience as a fire fighter and paramedic and the last 2 years have been doing aviation and road fuels at an Airport and bulk fuel installation

I have worked with all the various vendor representative from the manufactures as well as many after-market repair vendors from the UK, Germany, France, Italy, Canada, and USA.

Environmental Engineer and Senior Project Manager

I am graduated with M.Sc.Applied Geology with Specialization in Geophysics. I have completed my Internship with Oil and Gas development company (O.G.D.C) in geophysical data interpretation of oil well. I have also worked on different softwares like Golden software (surfer 8), Didger, QuickSyn.

A professional LNG Technician/Engineer is looking for a position where his skills and education will add value to operations.

Prevent / correct unsafe acts & condition.

Auto CAD 14/2000i/2004/2005/2006/2007,AutoCAD Map, CAD Overlay, Map Info7.0,Arc View3.2

Education:B.Tech (Civil), Pondicherry Engineering College, Pondicherry Univercity, in 1997. Skills: AutoCAD, MS Office, MS Project and Primavera. Trainings Undergone: Green & Red Code Accrediation program by CED, JAFZA

International field work resume(non-abbreviated)

Looking for work as an Industrial Engineer - biligual.

LOOKING FOR JOB IN ANY POSITION

B.E.(Electronics & Telecommunication) with good academic records. working as service engineer in R.K. engineering services private limited.

Over twenty years of experience

Mining Engineer with 20+ years experience, Supervisor of Drilling Crews, great work ethic, will meet deadlines and bottom line, effective team builder

QA/QC Engineer & Inspector for (Welding, NDT, Piping, Structure, Mechanical, Painting, Coating, Storage Tank, Electrical & Instrument) , Construction Supervisor and Field Engineer

Safety, Health, Quality, Environmental, Waste management, training, investigations, incidents, orientations,contractors, oil and gas, chemicals, construction, hazop, hazards, emergency response, job observations, near misses, safety alerts, hazard communications

Procurement & Supply Chain Management

Area lead designer, PDS ,Microstation, AutoCad, Smartplant review, Peligan Forge Support moduler.

INSPECTION and SUPERVISION (Welding / Piping / NDT / QA/QC / Mechanical / Materials / Coating and Painting).CSWIP 3.2,ASNT Level 3,NACE Coating Inspector,ISO Auditor

Quality Management, ISO 9001, ISO 14001, OHSAS 18001, Lead Auditor of IRCA, TUV-CERT

Had been involved in diversified organization for more than 7 years as Document Control, Management Information and Records Custodian. Knowledgeable in administering exchange of documents used of Document Control System, proper retrieval of documents in line with the ISO Standard and Procedures.

Seeking Chemist, Laboratory, or Quality Control Position

Worked in an oil and gas industry and undergone an intensive training .

MS-GIS, International MBA, Fluent english and spanish, basic Arabic

Perform repairs on Ford automobiles electical systems, drivetrain, driveability. Extensive training through Ford Motor Company.

Qualified HSE ADVISOR offshore, Drilling,production, pipelaying, french,48, immediately available

Project Management, Primavera P3E Scheduler

Instrument and Electrical Superintendent with over 30 years of experience in the construction field

First Prev 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 [ 184 ] 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 Next Last

Seach Parameters


Change search parameters...
INDUSTRIES: Petroleum/Oil/Gas;
Change search parameters...
Keywords: (e.g. mining engineer)		Find results with:


Save this search parameters...
Post job with this search parameters...

Frequently Asked Questions

What's the most effective way to perform a search?
Go to Advanced Search
1. Select 'Industries', 'Categories', 'Education', and 'Experience' fields. Click 'Search' and look through results.
2. Enter one or two of the most important keywords. Click 'Search' and look through results.
3. To search within results add more keywords.

How can I find resumes that contain specific exact phrase?
To search for an exact phrase, just put quotation marks around two or more words, for example "mining engineer". Use this feature to narrow your results or to find words that can be typed differently, for example AutoCAD "Auto CAD".

More Frequenly Asked Questions...

Employer's Center

» Employers Home

» Feedback

» Help

» Post Jobs

» Edit/Delete Jobs

» Search Resumes

» Resumes By Email

» My Account

» Log In

» Log Out