CONTACT INFORMATION:
View contact information...
JULY 2008 to September 2008: McCONNELL DOWELL. SINGAPORE
E&I FIELD ENGINEER
E&I Supervisor for Electrical and Instrument Shutdown and Tie-Ins Works for Future Expansion at the ExxonMobil Ethylene Plant. Main Duties Were Observing Installation of New MCC'S, New Motors and Cables, Upgrade of some Existing Motors, Upgrade of New Process Transmitters, Control and PSV Valves.
MAY 2008 to JULY 2008: RUBICON OFFSHORE INTERNATIONAL. MAP TA PHUT, THAILAND
E&I FIELD ENGINEER
E&I Field Engineering and Supervision for outstanding works on a FPSO. Recableing of Main Shaft Generator to Engine Room Switchgear and Topside Control Room Upgrades. Installing and Commissioning New Electrical Equipment CCTV System UPS, Rewiring Distribution Panels, New Emergency Lighting on Deck.
OCTOBER 2007 to FEBURARY 2008: BECHTEL. SIRACHA, THAILAND
ELECTRICAL FIELD ENGINEER
Performed Shutdown tie in's, Installation and Commissioning Activities on New 11kv Feeder Breakers, Transformers, 400volt Motor Control Centers. Performed Uncoupled/Coupled Motor Run in Testing for New Pumps and Fin Fans for the TPX Revamp Project at The Thai Oil Complex.
MARCH 2007 to SEPTEMBER 2007: TENGIZCHEVROIL.TENGIZ, KAZAKHSTAN
ELECTRICAL FIELD ENGINEER
Ensuring the Commissioning Activities on Power Management Controlling Equipment for Base Control of the 132kv Overhead Lines, Outdoor Substation, 33kv and10kv Electrical Distribution System. The PSC/SIS System was in Control for Generator Load Sharing, Load Shedding of Large and Non Critical Loads, Transformer Auto Tap Changers for Maintaining Bus Voltage and Generator Spinning Reserve.
AUGUST 2006 to FEBUARY 2007: CHEVRON/PHILLIPS. RAS LAFFAN, QATAR
ELECTRICAL FIELD ENGINEER
Ensured Electrical QA/QC On Design, Construction, and Installation of Equipment at the Ras Laffan Olefin Project. Inspections on 132 kv Overhead Line, 33.kv, 6.6kv, 415 volt Cables, Transformers, Switchgear and Motor Control Centers.
MARCH 2006 to MAY 2006: SHANGHAI LIANHENG ISOCYANATE. CAOJING, CHINA
ELECTRICAL FIELD ENGINEER
Hazardous Area Detail Inspections on Electrical & Instrument Enclosures. Verifying that Equipment and Construction Methods Utilized met the Requirement of Chinese and International Standards. Checks of Classified Areas on Motors, Control Panels, Instrumentation Transmitters, Vendor Package Units, Heat Tracing, and Lighting. Training of Local Staff for Future Operating Equipment Safety Checks in Hazardous Areas.
DECEMBER 2003 to FEBRUARY 2005: BRITISH PETROLEUM. BAKU, AZERBAIJAN
E&I FIELD ENGINEER
E&I QA/QC Inspections on Design, Construction, and Installation of Equipment on the Baku/ Tiblisi/ Ceyan Pipeline Crude Oil Pumping and Pigging Stations. Diesel Generation, Substation, Switchgear, Motor Control Centers, PLC`S, UPS, Process Control System,Intergrated Safety Shutdown System, Loop Diagrams, Fire & Gas, HVAC Equipment, Cathodic Protection, MOV`S, Transmitters, Motors, Lighting and Small Power, CCTV, and Various other Systems to Completion Thru Commissioning Stage. Training and Evaluation of Local Staff on Operating and Maintenance Procedures of all Electrical and Instrument Equipment.
MAY 2003 to SEPTEMBER 2003: BANGKOK WEST WATER TREATMENT. BANG LENG, THAILAND
ELECTRICAL FIELD ENGINEER
Supervision of Construction and Pre-Commissioning Activities Ensuring the Installation of an Outdoor 132kv Substation, Relay Control Panel, 22kv SF6 Ring Main Distribution System, Control Room DCS, PLC, Along with Energizing Transformers, 6.6kv, 380 Volt Motor Control Centers. Overseeing Testing of all Control Schematics and Loop Diagrams, Motor Run-in Tests.Cathodic Protection, Training of Local Staff on Switchgear and Motor Control Centers. Trouble Shooting Techniques of Plant Equipment. Safety and Maintenance Evaluation of Personnel during Plant Operations.
APRIL 2002 to MARCH 2003: MOTOROLA THAILAND. BANGKOK, THAILAND
ELECTRICAL INSPECTOR
Electrical Inspection of Microwave Communication Containers for the TA Orange/ Motorola Mobile Phone Project in Thailand. Testing of Rectifiers, Fire Control Panels, A/C Controllers and Compressor Units. Along with 380 volt Distribution Equipment.
SEPTEMBER 2001 to FEBRUARY 2002: WASTE MANAGEMENT THAILAND. BOWIN, THAILAND
ELECTRICAL CONSULTANT
Consultancy Works on 22kv Pole Line and Transformers along with Commissioning Activities of the 380 Volt Substations, Motor Control Centers, Motors, and Emergency Diesel Generator at their Waste Environment Complex.
MAY 2001 to AUGUST 2001: TEXACO / MESSER AGS SYNGAS. JURONG ISLAND, SINGAPORE
ELECTRICAL FIELD ENGINEER
Supervised Testing/Maintenance Activities on 33kv SF6 Switchgear, Transformers, 11kv and 400 volt Switchgear, Testing of Protection Relays, ESD Control Logic, Motor Control Centers. Planning and Setting up Temporary Power Supplies for Critical loads during a planned plant shutdown.
OCTOBER 2000 to APRIL 2001: ESSO THAILAND. SIRACHA, THAILAND
E&I FIELD ENGINEER
Quality Control Field Engineer on both Electrical and Instrumentation Equipment for the Addition of a 26mw Gas Turbine Generator Along with new Switchgear, Relay Protection Panel and Mark V Control System. Testing of all Control Interface Safety and Shutdown Loops. Enhancing the Stability and Efficiency to the Exxon Chemical Plant and the Esso Siracha Thailand Refinery. Training of Local Staff on New Generator Control System. Relay Function, Testing and Maintenance. Evaluation of Personnel during Construction and Startup.
JANUARY 1999 to AUGUST 2000: EXXON CHEMICALS. SIRACHA, THAILAND
ELECTRICAL FIELD ENGINEER
Ensured Electrical Construction and Commissioning Activities for Exxon Chemicals on the Thai Aromatics Recovery Project at the Esso Siracha Thailand Refinery. A new Outdoor 132 kv Substation along with 11kv, 3.3kv, 380 volt Switchgear and Motor Control Centers. Transformers, Cabling, Motor Run-in Test. Training and Evaluation of Personnel on Electrical Operation and Protection for new Outdoor High Voltage Equipment.
FEBRUARY 1998 to DECEMBER 1998: ESSO THAILAND, SIRACHA, THAILAND
E&I FIELD ENGINEER
E&I Field Engineer on the Low Sulfur Automotive Diesel Project which Consisted of Debottlenecking parts of the Refinery, Supervision and Testing over both 3.3kv and 380 volt Motor Control Center Extensions with New Motors/Pumps Being Commissioned. Adding Electric Actuators to Crude Movement Valves and Tank Gauging Transmitters with cabling to the Main Control Room being Installed and Loop Tested.
JANUARY 1997 to DECEMBER 1997: NAKORN-THAI STRIP MILL. BOWIN, THAILAND
ELECTRICAL FIELD ENGINEER
Ensured Electrical Equipment Design and Testing for Both Safety and Maintenance Purposes on 33kv, 6.6kv and 380 volt Switchgear. Emergency Diesel Generators, Testing of High Voltage Cables, Protection Relaying, Also Electrical Design Works/ Installation of Equipment for Lightning, Surge Protection to Protect PABX, UPS and Administration Building Utilities.
JANUARY 1993 to NOVEMBER 1996: ESSO THAILAND. SIRACHA, THAILAND
ELECTRICAL FIELD ENGINEER
Ensured Electrical Construction, Installation and Commissioning Activities on 132kv Overhead lines,11kv, 3.3kv, and 380 volt Transformers, Switchgear, Motor Control Centers, Two10mw Gas Turbine Generators, UPS Systems, Control Rooms, Loop Testing Remote Instrument Buildings, Substations, Motors, High Voltage Cabling, Motor Run-in Tests, HVAC Systems, Cathodic Protection, Plant and Area Lighting for The Grassroots Siracha Refinery. Training of Local Staff on Operation and Maintenance of Electrical Equipment, Motors, Switchgear, Relay Protection and Transformers. Writing of Maintenance Procedures and Record Keeping.
FEBRUARY 1991 to DECEMBER 1992: MANNESMANNS. SAUDI ARABIA
ELECTRICAL FIELD ENGINEER
Ensured Electrical Construction and Commissioning Activities for Mannesmanns Crude Oil Super Pump Pipeline Project and LNG Plants. This added 13.8kv, 4160kv and 480 Volt Transformers, Substations, Switchgear, Motor Control Centers, Control Rooms, UPS, HVAC, Cathodic Protection and Control Buildings for the Gas Turbine Pumps in Eleven Pumping Stations across Saudi Arabia.
1985 To 1991: POWELL ELECTRICAL MANUFACTURING. HOUSTON, TEXAS USA
ELECTRICAL QA/QC INSPECTOR
Provided Final Factory Assembled QA/QC Inspection of Industrial Electrical Substation Buildings, High Voltage Switchgear, and Motor Control Centers. Testing Activities Included Three Phase Primary Injection of Switchgear, Function Testing of Relay and Breaker Control Logic Circuits. Relay Secondary Injection Testing. Correctness of Dimensional and Mechanical Alignment of all Equipment. Checked Clearances, Sizing, Ductor, Hipot Testing of Bus Bars and Breakers Using ANSI, NEC, NEMA, NFPA,IEC and other Standards. Performed Factory Acceptance Tests for the Visiting Clients. Marked Up Final As Built Shop Drawings. Prepared Buildings, Switchgear and Equipment for Shipment to Project Sites World Wide.
1983 To 1985: NALCO CHEMICALS. FREEPORT, TEXAS USA
JOURNEYMAN ELECTRICIAN
Provided Maintenance on Pneumatic and Electronic D/P Cell Transmitters, Process Controllers, Recorders Pneumatic, Actuators, Solenoid Valves, Capacitance Level Probes, Multi-Point Temperature Recorders, Transducers, ph Meters, Chlorinators, Pneumatic Controlled Fire Protection Systems, Pressure Switches and Gauges. As an Electrical / Instrument Mechanic for Nalco Chemicals to Ensure Minimum Downtime and Maximum Equipment Life.
1982 To 1983: ANHEUSER-BUSCH. HOUSTON, TEXAS USA
JOURNEYMAN ELECTRICIAN
Provided Maintenance on Three-Phase Motors / Starters, Control Circuits, Photo Eye Relays, Timers, Counters, Quality Control Inspection Equipment, Level Sensors, Solenoid Valves, Control Panels, Limit Switches, Relays and Electrical Switchgear as a Maintenance Electrician for Anheuser- Busch.
1981 To 1982: TECHNICAL MAINTENANCE. HOUSTON, TEXAS USA
JOURNEYMAN ELECTRICIAN
Ensured Electrical Maintenance on Explosion Proof Starters, High Voltage Switchgear, Control Circuits, Pressure Switches, Indicators Controllers, and Panel Alarms as an Electrical / Instrument Mechanic for Technical Maintenance in Support of Numerous Petrochemical Client Contracts.
1977 To 1981: INTERNATIONAL MINERALS AND CHEMICALS. MULBERRY, FLORIDA USA
JOURNEYMAN ELECTRICIAN
Performed Electrical Maintenance on 5kv Synchronous Motor Starters, 480-volt Motor Control Centers, Control Circuits, Level Alarms, Zero Speed Switches, Control Panels, Conveyor Belt Systems, Very Large Electric Draglines and Plant Lighting as a Journeyman Electrician for International Minerals and Chemical.
EDUCATION / TRAINING
DESIGN COURSES FOR METAL CLAD SWITCHGEAR AND RELAY PROTECTION TECHNICAL TRAINING AT POWELL ELECTRIC. HOUSTON TEXAS. ONGOING PROGRAMS FOR NEW OEM EQUIPMENT.
COLLEGE OF THE MAINLAND. TEXAS CITY, TEXAS. TECHNICAL INSTRUMENTATION. ONE-YEAR PROGRAM. COMPLETED 1984.
TPC TRAINING SYSTEMS. BARTOW, FLORIDA. INDUSTRIAL ELECTRICAL APPRENTICESHIP. FOUR-YEAR PROGRAM. GRADUATED 1981.
POLK VOCATIONAL TECHNICAL CENTER. LAKELAND, FLORIDA. ELECTRICAL CONSTRUCTION, WIRING AND MAINTENANCE. TWO-YEAR PROGRAM. COMPLETED 1977.
________________________________________
View contact information... |