Resume - Experienced in power plant operations and startup.

Misco Jobs

Resume #4241

CONTACT INFORMATION:
View contact information...

License held

Arkansas high pressure boiler operators

Career Summary

June 2003 to Present

Contracted to Gemma Power for Operations Supervision

Provided Operations Supervision for the commissioning of a two on one combined cycle plant. The plant consist of two Siemens Westinghouse 501 gas turbines and one Siemens Westinghouse steam turbine, plant controls are Ovation.

Sept 2002 to May 2003

TMP Worldwide - Contracted to Progress Energy as a Control Room Operator

Operator for the commissioning of a two on one combined cycle plant. The plant consist of two GE frame 7 gas turbines and one Toshiba steam turbine, plant controls are Ovation. Other duties include operation 3 GE frame 7 simple cycle units.

Cleco Sept 2001 to Sept 2002

On the commissioning crew at a 650MW merchant power plant. The plant consist of 3 GE frame 7 gas turbines and one GE steam turbine, plant controls are Baily Infinet 90.

Siemens Westinghouse Sept 2000 to Sept 2001

Operator at a 500MW merchant power plant using 2 Siemens Westinghouse V84 single shaft gas/steam turbines with Teleperm DCS. On the commissioning crew for unit two.

Potlatch Oct 1998 to Sept 2000

Employed in a Paper Mill, worked in the shipping & extruding department, powerhouse and pulp mill. Performing various task through out the mill including; operating forklift, dozer, performing test on boiler chemicals including black and green liquor.

Trigen Bio-power Feb. 1998 to Oct 1998

Employed as a Control Room Operator in a 7MW-cogeneration plant. Responsible for safe operation and maintenance of plant equipment, water test and record keeping. Plant consists of Rice hull gasifiers, boiler, Westinghouse steam turbine and various support equipment. Plant is controlled by PC based Wonderware.

Self Employed April 1996 to Jan. 1998

Self employed as a small business owner

Mission Operations & Maintenance, San Ardo. CA. June 1991 to April 1996

Worked as an Operator 1 at Sargent Canyon Cogeneration Plant. On the commissioning crew. Responsible for safe operation and maintenance of plant equipment, monitoring plant status using a Westinghouse WDPF DSC, equipment readings, working with the environmental coordinator to ensure that we were in compliance with EPA standards for storage and disposal of all chemicals and water test. Plant consist of a G.E. Frame 6 gas turbine using combustion burners firing a Nooter Eriksen HRSG and this position required working with minimal supervision.

Bechtel, King City, CA. Feb. 1990 to June 1991

Worked as a B Operator at American 1 cogeneration plant. The plant consists of a G.E Frame 7 gas turbine, an ABB VAX steam turbine and support equipment. Responsibilities included operations, maintenance, equipment readings and water test.

U.S. Navy Jan. 1984 to Dec. 1989

My six years in the Navy, Duties included time spent as Engine Room Operator responsible for the operation and maintenance of all Engine Room equipment. As an Oil King responsible for water chemistry of three waste heat boilers, fuel testing, lube oil testing and record keeping.

View contact information...

«« previous resume

next resume »»

Search Results (Resumes 1151 to 1200 of 4814)

Go to Search Parameters...

Brief Description

A DIPLOMA IN MECHANICAL ENGINEER HAVING 20 YEARS EXPERIENCE IN CONSTRUCTION FOR VARIOUS INDUSTRIES LIKE CROSS COUNTRY PIPELINE, CEMENT, CHEMICAL, FERTILISER, POWER, ETC., PRESENTLY FOR THE PAST 7 YEARS WORKING AS A DY. MANAGER (CONSTRUCTION) WITH SIMON INDIA LIMITED, INDIA.

Truck driver

June 2003 ©¦EPresent Company: JGC Corp Location: China Position : Schedule Controller May 2002 ¨C March 2003 Company: FAFCO Location: Saudi Arabia Position : Planning & Scheduling Engineer

A professionally qualified Engineering Project Manager, with a total commitment to excellent performance, combining experience that encompasses a broad range of technical and management skills well as practical, ‘hands-on’ involvement.

Seeking a Operation Manager position. Offer extensive hands-on and supervisory experience in multimillion-dollar commercial projects within the construction industry."

I have 20+ years as a Welder. I have numerous certifications in Welding Procedures. I am willing to relocate and/or travel.

20+ years in EPC heavy/industrial. Sharpest skills in resource & time control. Expert Planner/Scheduler w/Primavera P3, P3e Teamplay etc. software, 14 years experience (superuser & administrator). Capable Cost Engineer & Good communicator.

Registered California architect with 14 years construction management experience acting as owner representative for governmental agencies managing the design and the construction of various types of facilities.

Enriching a company in the Mid-Atlantic building products market.

Moving to Georgia Thomaston Area need work.. by 4/01/04

35 continuous years of national and international commercial construction experience

The resume summary is included in the resume.

I am very experienced and have worked at all levels worldwide and also worked with many nationalities. I work very hard and get on well with everybody.

Mechanical & Electrical Engineer Location East London, Essex, Kent, Greater London Salary To £30,000 plus package

Safety Manager seeking position

Crane Operator

Civil Engineer with solid background in structural design, experience working with oil companies. Project supervision experience, costing and evaluation. Vast field experience leading working crews and supervising jobs. Good communications skills. Multilingual, speaking Spanish, French and Italian.

Experienced in power plant operations and startup.

international c.v.

Mining Engineer and Geologist with twenty-seven years’ experience in precious and base metals, coal and industrial minerals. Professional Engineering licenses in three states, with unique construction and engineering achievements. Advanced technical and strong supervisory skills.

Work Experiences : Mechanical equipment and piping installation in the following industrial plants: 1) Natural gas plant 2)Power plant 3)Polypropylene plant 4) Oil Refinery 5)Desalination plant 6)Steel mill 7)Foundry plant(maintenance of mechanical equipment)

I have been working in construction industry for Oil & Petrochemical Plant for decades. I work well under pressure and very keen on project planning and management. I am confident in leading a team of sub-contractors in performing sophisticatedly for any petrochemical processing plant.

NACE Certified Coating Inspector #7278, with +20 years of experience, available as (3rd party) Q.A./Q.C. coating inspector, coating surveyor, coating supervisor, vendor surveillance, etc.

I have been working in the Construction Industry for 40 years at all levels up to Construction Manager. I have extensive experience overseas including Africa and Asia. I am looking for similar work and am prepared to work anywhere at immediate notice.

23 years experience in the Electrical Distribution/Electrical Contractor Industry. Wish to acquire a part time or full time position in an office or job site environment.

Job objective: General Supervisor, Field Supervisor, Project Manager or Assistant Project Manager. Interested in overseas opportunities.

Looking for a new challenge at the end of 2003 my present contract end then

C/C++/ VB / SCADA / Electronic / Embedded / Automation / Systems Engineering

I completed my degree in Electrical Engineering and had taken and passed the highest National Examination in The Philippines, Professional Electrical Engineers Examinations in 1986. I have a good experience in Oil and Gas, Controls, Fire and Gas Systems, Design, Detailed Autocad Drafting(Isometric),

Erection, Commissioning field instruments & Systems

Over 23 yrs of heavy earth field mechanic. AAS in Heavy equipment and diesel Technology. Lack final semester for BA in Training Industry & Business. CAT and Kamatsu trained.

AutoCAD, PDS (3-D modeling). Lead engineer of erection department

Ex-Pat experience in international Supply Chain, Logistics, Process, and Project Management

Diploma general nursing (midwifery,community nursing,psychiatry),Diploma in occupational health nursing,SAMTRAC

Safety or hse officer,4.5yrs exp

Document Controller, Planning Assistant, Admin Assistant

Instrument engineer with around 15 yrs of versatile experience in the field of installation,commissioning , operation amd maintenance.

Civil engineer from India , Now i am working in oman since 2007 , feb . I want a site engineers jobs in australia .For that i need employer sponsored visa.

Riview contract, Claim of insurance, Invoicing , Claim od additional and variation works, Count the Quantity progress.

I can offer extensive supervisory experience in the oil and gas industry,

Electrical engineering on EPC projects, analyses of power distribution grid, FEED design of power distribution and power generation systems, detail design of power distribution in hazardous and non hazardous areas, technical coordination of subcontractors and procurement on projects, site supervisi

Over 25 years of diverse and successful experience in material control in areas including: Nuclear/Coal Power Generation, Bulk Handling & Storage, Co-generation, Commercial Maintenance, Oil Refinery, Warehouse/Distribution, Shutdown/Turnaround and Outages.

Experience in all phases of material management & expediting, design office & engineering & project coordination. Experience in heavy construction including offshore oil platforms & related facilities, nuclear fuelled power plants, paper mill, chemical plant & overseas military facilities.

I am a Graduate Mechanical Engineer and have good proficiency in Computers. I have put in 13 years of hard work in Construction of Oil & Gas Pipelines, which has given me exposure in all fields like Project Management, Planning, Tendering, Cost Estimation and Control, Execution.

Geodesist/Land Surveyor/Geomatics/GIS consultant

Project Manager with over 35 years of experience in the construction industry, which offers an extensive and diversified array of industries such as power generation, pharmaceutical, semiconductor, large office facilities, pulp/paper and plastic projects, coal gasification and others.

Highly motivated and results-oriented professional with exceptional leadership and interpersonal skills with an extensive background in construction industry.

A competent Chartered Mechanical Engineer with over 14 years experience, gained in Aluminium, Iron & Steel, Nuclear & Petrochemical Industries. Worked in areas of Design, Construction, Installation, Projects, Commissioning, Overhead Cranes and SAP.

Piping/Mechanical Superintendent

System Admin for IT Industry.

First 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 [ 24 ] 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 Next Last

Seach Parameters


Change search parameters...
INDUSTRIES: Construction;
Change search parameters...
Keywords: (e.g. mining engineer)		Find results with:


Save this search parameters...
Post job with this search parameters...

Frequently Asked Questions

What's the most effective way to perform a search?
Go to Advanced Search
1. Select 'Industries', 'Categories', 'Education', and 'Experience' fields. Click 'Search' and look through results.
2. Enter one or two of the most important keywords. Click 'Search' and look through results.
3. To search within results add more keywords.

How can I find resumes that contain specific exact phrase?
To search for an exact phrase, just put quotation marks around two or more words, for example "mining engineer". Use this feature to narrow your results or to find words that can be typed differently, for example AutoCAD "Auto CAD".

More Frequenly Asked Questions...

Employer's Center

» Employers Home

» Feedback

» Help

» Post Jobs

» Edit/Delete Jobs

» Search Resumes

» Resumes By Email

» My Account

» Log In

» Log Out