Resume - Electrical Engineering, Energy Systems, Power electronics

Misco Jobs

Resume #81206

CONTACT INFORMATION:
View contact information...

OBJECTIVE
Seeking a challenging full-time Energy Engineering position that utilizes my education and technical skills.

EDUCATION
* State University of New York (SUNY) at Buffalo
* Master of Science, Electrical Engineering, May 2009
* Achieved 'A' grade (4.0/4.0) in all courses taken during second and third semester including multiple courses in the area of Microelectronics.
* Teaching Assistant, Introduction to Nano Electronics
* Awarded Teaching assistant-ship and stipend for academic excellence.
* Conducted classes to assist students perform better in the course.
* Prepared course material and graded assignments.
* Anna University, India
* Bachelor of Engineering in Electronics and Communication, May 2006
* Achieved top results in courses like advanced electronic circuits, electric circuits, Mobile Cell.

SKILLS
* Programming Languages: Verilog HDL, C.
* Hardware Design Tools: Cadence, SPICE, Xilinx ISE, ModelSim, HFSS, Spectrum Analyzer, MAGIC7, Auto CAD.
* Strengths: Computer Architecture, Digital Electronics, Analog Circuits, Integrated Power Electronics.

ACADEMIC PROJECTS
* LED Driver and Photo receiver [Analog Circuits, SPICE]
* Designed, laid out and simulated a chip for fabrication that drives an LED and detects the received light signal.
* Voltage Controlled Oscillator was designed to drive a particular led specification.
* Designed a High Gain Amplifier with low power consumption to detect the received light signal.
* Implemented a Detection Circuit to trigger an alarm above a reference voltage.

* Electronic Security System [Verilog, FPGA, Xilinx]
* Designed and Burnt a FPGA combination lock circuit for security systems.
* Implemented the logic in Verilog using Xilinx ISE 10.1 and tested simulations on ModelSim.

* ASIC Multiplier and Accumulate Unit [VLSI,Cadence]
* Designed, laid out and simulated an ASIC CMOS based Multiply–Accumulate circuit using Cadence SpectreS in 0.6 micro meter technology.
* Implemented the Modified Booth Algorithm and obtained substantial gain in calculation time.

* RF Microwave Research [Spectrum Analyzer, HFSS]
* Independently involved in research by conducting experiments to study the mode conversion in RF microwave waveguides. Cut-Off frequencies in spectrum analyzer were compared with HFSS.
* Comprehensive research and study was performed on various components and equipments like antenna, dielectric material and waveguides.

PROFESSIONAL EXPERIENCE
Engineer I, Larsen and Toubro InfoTech LTD, India June 2006 - July2007
* Designed, Developed and provided technical support for Migration management system.
* Worked, interacted with Freescale Semiconductor and other clients for system requirements and specifications. Fixed multiple production problems in record time.
* Received an award for outstanding performance and growth.

EXTRA CURRICULAR ACTIVITIES
* Vice President, Electrical Engineering Graduate Student Association at SUNY, Buffalo.
* International Student and Scholarly Services Orientation Volunteer, August 2008.
* Volunteer Assistant to fellow student with a disability, fall 2008.

View contact information...

«« previous resume

next resume »»

Search Results (Resumes 3351 to 3400 of 4814)

Go to Search Parameters...

Brief Description

Experience in Instruments of PERKIN ELMER and applied bio-system, installation, commissioning, maintenance, and calibration of various instruments;

Applying for the post of safety officer in your esteemed concern

Academic Background:M.Sc.Tech. (1987), Applied Geology, Indian School of Mines, Dhanbad, India. Expertise: Engineering Geology and Rock Mechanics in the field of rock engineering

Purchaing, Procurment, Supply Chain Management, Materails, Inventory

Over 20 Years Industrial, I&E Commissioning Field Service Engineer /Electrical Start-up Engineer

I have worked as a chef in extreme conditions in the past. nothing i can't handle big or small jobs.

I am Tank and piping/pipeline / structure Superintendant

A Buyer /Expeditor with 18 years Gulf experience

Welding Engineer, ASME,AWS D1.1, Welding Inspection, Welding supervision

Familiar with all steps of equipment, structure fabrication and piping installation as pertinent specification, document control, subcontractor management knowledge, claim representation and site safety conception.

I am a hardworking, motivated aboriginal seeking an entry level position on an oil rig. I have obtained certificates such as WHIMS, H2S alive, and standard first aid.

I'm the Safety Manager for the company I'm with now...

I am looking to secure a full-time position with a growing company that is well established in the area and offers their employees room to advance in their chosen field

Pip in indistrial safety, working in ministry of elec & water ,kuwait.

Computer Technician

Principal Environmental & Safety Consultant, oil, gas, mining & major projects; EIA, EMS, Environmental risk etc, climate change, HAZOP, HAZID, Safety managment etc experience. Relocating to Vancouver. Has right to live and work in Canada

Cad Drafter/Designer

Automobile related

Mechanical Engineering Graduate EIT - experience at underground mine sites, maintenance planning, drafting in autodesk inventor, physical asset management, underground mine hoist ropes and lubrication, scheduling

Eight years of experience in the field of Mechanical Engineering Works that primarily concerns on overall mechanical system and details design as well as fabrication.

Electrical Engineering, Energy Systems, Power electronics

I am Diploma in Mechanical Engineering. I have adequate knowledge in Auto-Cad in mechanical engineering field. I also have confident experience in X-Steel & SDS2 in steel structure back ground.

Graduate Electrical with Power Electronics

Sub.: Power plant /Utility Electrical Maintenance Engineer

B.Com (Commerce, MS-Word, MS-Excel, Tally, Emails, Internet & Other Software

Pipefitter with supervisory and training facilitator experience

At present doing a 2 year contract at a bulk fuel installation, in Basrah, Iraq, as an Operator. I have 25 years experience as a fire fighter and paramedic and the last 2 years have been doing aviation and road fuels at an Airport and bulk fuel installation

I am graduated with M.Sc.Applied Geology with Specialization in Geophysics. I have completed my Internship with Oil and Gas development company (O.G.D.C) in geophysical data interpretation of oil well. I have also worked on different softwares like Golden software (surfer 8), Didger, QuickSyn.

Prevent / correct unsafe acts & condition.

Project Manager - Sales - Technical

Education:B.Tech (Civil), Pondicherry Engineering College, Pondicherry Univercity, in 1997. Skills: AutoCAD, MS Office, MS Project and Primavera. Trainings Undergone: Green & Red Code Accrediation program by CED, JAFZA

A Mechanical Engineering graduate from NIT/KREC SURATKAL INDIA with over 19 years of experience in mining sector with over 7 years as Head of Maintenance operation in underground as well as open pit mine.Presently working as SBU head with responsibilities including planning,procurement,budget prep.

Over twenty years of experience

Mining Engineer with 20+ years experience, Supervisor of Drilling Crews, great work ethic, will meet deadlines and bottom line, effective team builder

QA/QC Engineer & Inspector for (Welding, NDT, Piping, Structure, Mechanical, Painting, Coating, Storage Tank, Electrical & Instrument) , Construction Supervisor and Field Engineer

Safety, Health, Quality, Environmental, Waste management, training, investigations, incidents, orientations,contractors, oil and gas, chemicals, construction, hazop, hazards, emergency response, job observations, near misses, safety alerts, hazard communications

Procurement & Supply Chain Management

INSPECTION and SUPERVISION (Welding / Piping / NDT / QA/QC / Mechanical / Materials / Coating and Painting).CSWIP 3.2,ASNT Level 3,NACE Coating Inspector,ISO Auditor

Quality Management, ISO 9001, ISO 14001, OHSAS 18001, Lead Auditor of IRCA, TUV-CERT

Had been involved in diversified organization for more than 7 years as Document Control, Management Information and Records Custodian. Knowledgeable in administering exchange of documents used of Document Control System, proper retrieval of documents in line with the ISO Standard and Procedures.

Seeking International, full-time position in Central, South America with a mining company for the development and management of capital projects. Peruvian Residency Available, Spanish, Project Management and Construction Experience with Heap Leach and Tailings Facilities

MS-GIS, International MBA, Fluent english and spanish, basic Arabic

Civil Engineer To render quality service to the company that I may be a contributory factor in achieving the company’s objectives.

Qualified HSE ADVISOR offshore, Drilling,production, pipelaying, french,48, immediately available

Project Management, Primavera P3E Scheduler

Instrument and Electrical Superintendent with over 30 years of experience in the construction field

I have 13 years of experience in,mining and oceanography,i have worked in an institition where i held leading posts and have been able to achieve all the set cooperative startegies in the shortest time as possible

Instrument Engineering, Fire & Gas Engineering

Manager / Engineer ( HW/SW/QA/Training )

Bachelor of Engineering (Mechanical) from Adiparasakthi Engineering college, Melmaruvathur, Madras university. (April 2002)

First Prev 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 [ 68 ] 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 Last

Seach Parameters


Change search parameters...
INDUSTRIES: Construction;
Change search parameters...
Keywords: (e.g. mining engineer)		Find results with:


Save this search parameters...
Post job with this search parameters...

Frequently Asked Questions

What's the most effective way to perform a search?
Go to Advanced Search
1. Select 'Industries', 'Categories', 'Education', and 'Experience' fields. Click 'Search' and look through results.
2. Enter one or two of the most important keywords. Click 'Search' and look through results.
3. To search within results add more keywords.

How can I find resumes that contain specific exact phrase?
To search for an exact phrase, just put quotation marks around two or more words, for example "mining engineer". Use this feature to narrow your results or to find words that can be typed differently, for example AutoCAD "Auto CAD".

More Frequenly Asked Questions...

Employer's Center

» Employers Home

» Feedback

» Help

» Post Jobs

» Edit/Delete Jobs

» Search Resumes

» Resumes By Email

» My Account

» Log In

» Log Out