Resume - INSTRUMENTATION ENGINEER

Misco Jobs

Resume #88434

CONTACT INFORMATION:
View contact information...

OBJECTIVE
To work in a dynamic and challenging job environment where I will be able to significantly contribute to the organization's requirements while continuously enhancing my skill-set.

EDUCATION

Graduation
* B.Tech in Applied Electronics & Instrumentation from LBS Institute of Science and Technology, University of Kerala with first Class (66.6%) in 2008
Higher Secondary
* Completed Higher Secondary in 2004, Board of Public Examinations,
Government of Kerala (71.3 %) with first class from Govt. Cotton Hills G.H.S.S
Schooling
* Completed SSLC in 2002, Board of Public Examinations,
Government of Kerala. (89%) with distinction from Govt. Cotton Hills G.H.S.S

Software Proficiency:
C++, C#.net, AutoCAD 2007

Experience:

Presently working as Instrumentation Engineer in a petrochemical consultancy
(Petrocil Engineers and Consultancy), Sasthamangalam, Trivandrum, Kerala.
(From 01/10/2008 -presently).

E-mail id - supriya.sr@petrocil.com

Responsibilities of job:
Preparation of the following Instrumentation drawings/documents:
* Technical Instrument Datasheets.
* Instrument Index/Schedules.
* Cable Sizing Calculations.
* Equipment layouts.
* Instrument Cable routing/tray layouts.
* Instrument Cable schedule.
* Block diagrams of Instruments.
* Instrument Hookup drawings.
* Instrument Loop and Logic diagrams.
* Wiring/schematic, Interconnection diagram, termination details.

Academic Mini project
Linear Angular Frequency Meter (LAFM):

Linear angular frequency meter is a device which accurately determines the frequency of input signal. With the help of selection mode it can distinguishes between linear and angular input. We just press the start button for frequency display. The device computes the number of pulses in 1 second, which it is implemented using microcontroller AT89C51. It is a low power, high performance CMOS 8-bit microcontroller with 4k bytes of Flash Programmable and erasable read only memory. In this product micro controller is used as a counter. i.e. to count the number of pulses at the output either optocoupler module or squaring circuit. Optocoupler is used for the measurement of angular frequency. It consist of LED and phototransistor in a module, we get the pluses as output.
The device can be effectively used in areas which require accurate frequency determination.

Academic Main project
Design of RS485 Tran receiver Protocol Controller:

To obtain a design of RS 485 Transreceiver protocol controller using VHDL. RS 485 is the communication standard defined by EIA. The RS 485 standard permits a balanced transmission line to be shared in multi drop mode. Maximum of 32 driver/receiver pairs can share a multidrop network.EIA-485 is an OSI model physical layer electrical specification of a two wire, half duplex multi point connection.
In our project there are mainly three major blocks: Transmitter, receiver and a baud rate generator. The baud rate generator is the crucial block that provides the proper clock for the transmitter and receiver for proper synchronization and working, for proper functioning, the synchronization between the transmitter and receiver is necessary. The function of baudrate generator is to generate local clock signal.
We have undertaken here to obtain a simple model of RS 485 Trasreceiver protocol controller using VHDL; it stands for VHSIC (Very High Speed Integrated Circuit) hardware description language. Coded and simulated the model. Coding involved converting the basic operation into VHDL code. Simulation involves the generation of various waveforms associated with the code.

PERSONAL INFORMATION
Sex: Female
Marital Status: Single
Nationality: Indian
Hobbies: Enjoying music, Net surfing
Date of Birth: 05/05/1987

Activities and Achievements:

„« Contributed articles for college and school magazines,
„« Active participant in College sports meet.
„« Won prize in short story writing in Youth Festival
„« Student representative in 10th &12th
„« Active member in nature club and NSS

Reference
Will be provided

View contact information...

«« previous resume

next resume »»

Search Results (Resumes 301 to 350 of 458)

Go to Search Parameters...

Brief Description

With over 14 years experience in Camp and Catering Management and a long practice of difficult countries ( Nigeria, Angola, Myanmar(ex Burma), Iran, Algeria, Kosovo, and Afghanistan), I believe I could make a significant contribution in helping The Company achieve its goals and objectives..

Geologist

Maintenance Manager/Supervisor - Direct hands-on experience in the start-up of a large hydroforming/manufacturing facility. Excel at directing a cohesive staff in the successful attainment of objectives. Major strengths in planning, problem solving and communication.

MSc in Management Finance,BS(Hons) in Business Administration, ACCA, CAT

Early career Supply Chain Management & Project Management Graduate

Accounts Professional having 5.8 years of an experience.

Am a hard working and reliable person who displays a high standard of care and customer service, a person who is highly active, self motivated, keen to succeed and eager to learn new skills. Am good team worker and I know how to prioritise my work.

Administration, Marketing, Business Development, Operations & Computers

Industrial Projects Management / Engineering Design,Purchase / Supply Chain Management.,Installation, Erection and Commissioning of Machinery,Business Development,Material Management.

Oil & Gas Land Title, Leasing, Right of Way, Consulting & Reporting

A highly skilled and very experienced Supply Chain Professional with over 20 year's expertise in Logistics, Procurement and Materials Control mainly overseas.

I have completed CA - Inter and currently a Chartered Accountant - Finalist from Institute of Chartered Accountants of Pakistan. I am working with Ernst & Young Global Limited in Karachi office for the last 4 years and currently my designation is Senior Auditor.

Over 08 years experience in IT/IS with around 04 years of expereince in JD Edwards implementaion in technical and funtional role, proficient in coordinating overall project execution to ensure inter-project dependencies are properly identified and managed, familiarity with Project Management methodo

Seasoned expat. Strong broad-based tech skills and extensive project O&M exp in frontier third world environments. Road const, water rehab, airports, infrastructure rehab. Extensive EPL/EPC exp as Project Eng.

INSTRUMENTATION ENGINEER

Planning, Scheduling, Primavera, Risk management, Pertmaster

Mechanical Engineer with wide experience in Manufacturing, Maintenance, Sales and Service, Application Engineering, Project Engineering and Administration. Total experience of 30 years. Can work in any field like Construction, Hospitality Industry and Process Industry.

Human Resources Generalist

B2B Marketing, Product Development, Dealer Management, Market Research

Project Manager, Plant Technical Manager, Interface Engineering Coordinator, Pre-commissioning Engineer, Commissioning Engineer, Start-up Engineer, Process Engineer, Chemical Engineer

Involved in all construction activities including fabrication , installation and control off all structural items.Steel structural estimates include, pipe-racks, elevated pipe supports, pump shelters, access platforms, handrails, et

I have ability on heavy duty equipments operation,fms dispatch system using high technologies,mine supervision as well.

Dynamic Health & Safety Coordinator Looking For Work In Mining, Heavy Construction Or Oil Industry

Occupational Health Safety & Environmental Practitioner, Post Gruate Cert. in OHS&E Management

Workplace Safety Health Environment Coordinator - Moreton Island Oil Spill Clean Up Project

I have my fisrt degree in ghana in one of the best universities in the country as well and am currently working with one of the biggest mining company in the country too.

5 years experience in Secretary work, Administration support and Branch manager assistant - team support to senior and management level in a multinational company

an economics graduate from olabisi onabanjo university. i also belong to a professional memeber of the institute of chartered accountant of nigeria.

Higher Diploma In Business And IT, UBS Computerised System, Basic Knowledge Of Computers And Web Publishing

HSE ENGINEER AND SUPERVISOR

Oracle, LPN, 3PL, Supply Chain, Imports, Logistics

Twenty-two years in leadership and management with ten years experience in the Petrochem/Paper Mill industry. Ten years in health and safety in the fields of general construction, maintenance, Turn Around/Shutdown. Able to identify at risk behaviors, trends, and policy infractions through observati

Experienced CAD-GIS Professional/Consultant with years of experience in Autodesk design softwares such as AutoCAD, Civil 3D, Map 3D, MapGuide Enterprise and Raster Design.

Working as a Piping Supervisor in the field of Oil/Petro-Chemical industries Maintenance & Project Work.

Good Mam/ Sir My name is Denver Moodley. I am a qualified Advanced Life Support Paramedic working in Africa for International SOS remote site projects. I am keen to explore the option of Contract work with better opportunities and would be grateful if you consider my placement in one of your remot

HUMAN RESOURCES PROFESSIONAL

Training Coordinator

I have done B.Sc Chemistry with First class & also i have prior experience in Bhart Petroleum Co. Ltd as a Process Trainee.

Oil and Gas Leasing, Mineral Title research for the purpose of Leasing, Building Drilling Title Runsheets for Title Attorneys and Title Opinions, Title data entry, Deed plotting, Right of Way Title, Right of Way Acquisition

Security, life support, camp management, logistics

I am an enthusiastic highly motivated Quantity Surveyor / Cost Engineer, with an excellent working knowledge of pre & post contract quantity surveying and also pro-active team member with experience of major construction projects. I have gained deep awareness of contract administration and advanced

Five-year experience in metallurgical projects from the Gold and Nickel industry. Two-year plant and pilot plant experience. Speak, read and write English and Chinese (Mandarin). Familiar with pressure leaching at high temperature.

Sr.Chemist / Chemist , Quality Assurance / Control , Researching and Development, Production Supervisor Or eq. Position.

I am a motivated graduate with qualifications in Geological Engineering, Applied Petroleum Geoscience and Quantity Surveying and I am proactive, confident with excellent communicative skills. I am flexible in my approach work, accurate and punctual. I am focussed and motivated with eye for details

I am a seasoned QMS Internal & External Auditee, a trained QMS Internal Auditor and Document Controller, currently managing the implementation of ISO 9001:2008 (QMS) for a company in Nigeria. I have over five years experience in both Oil and Gas industry and Insurance Company working as document con

Strong English verbal and written communication skills • Specialized knowledge in MS Office suite- Outlook, and filling out DD Forms • Computer literacy in word processing, database maintenance, and spreadsheet software

Recently graduated with a Bachelor Degree in Business Administration (5/2007). Worked at Bisco Industries as a Management Trainee/Sales, 11/2007 – 07/2009.

Professional ROW Agent and Landman

Free! Esri Software Senior Developer

I perform a variety of duties as well as working in a collaborated team player environment; 3 plus years of experience in clerical work as well as Customer Service work; Ensure that the necessary quality records are specified, generated and controlled in accordance with the appropriate procedures;

1 2 3 4 5 6 [ 7 ] 8 9 10

Seach Parameters


Change search parameters...
CATEGORIES: Administration; INDUSTRIES: Environmental;
Change search parameters...
Keywords: (e.g. mining engineer)		Find results with:


Save this search parameters...
Post job with this search parameters...

Frequently Asked Questions

What's the most effective way to perform a search?
Go to Advanced Search
1. Select 'Industries', 'Categories', 'Education', and 'Experience' fields. Click 'Search' and look through results.
2. Enter one or two of the most important keywords. Click 'Search' and look through results.
3. To search within results add more keywords.

How can I find resumes that contain specific exact phrase?
To search for an exact phrase, just put quotation marks around two or more words, for example "mining engineer". Use this feature to narrow your results or to find words that can be typed differently, for example AutoCAD "Auto CAD".

More Frequenly Asked Questions...

Employer's Center

» Employers Home

» Feedback

» Help

» Post Jobs

» Edit/Delete Jobs

» Search Resumes

» Resumes By Email

» My Account

» Log In

» Log Out