Resume - Electrical Engineering, Energy Systems, Power electronics

Misco Jobs

Resume #81206

CONTACT INFORMATION:
View contact information...

OBJECTIVE
Seeking a challenging full-time Energy Engineering position that utilizes my education and technical skills.

EDUCATION
* State University of New York (SUNY) at Buffalo
* Master of Science, Electrical Engineering, May 2009
* Achieved 'A' grade (4.0/4.0) in all courses taken during second and third semester including multiple courses in the area of Microelectronics.
* Teaching Assistant, Introduction to Nano Electronics
* Awarded Teaching assistant-ship and stipend for academic excellence.
* Conducted classes to assist students perform better in the course.
* Prepared course material and graded assignments.
* Anna University, India
* Bachelor of Engineering in Electronics and Communication, May 2006
* Achieved top results in courses like advanced electronic circuits, electric circuits, Mobile Cell.

SKILLS
* Programming Languages: Verilog HDL, C.
* Hardware Design Tools: Cadence, SPICE, Xilinx ISE, ModelSim, HFSS, Spectrum Analyzer, MAGIC7, Auto CAD.
* Strengths: Computer Architecture, Digital Electronics, Analog Circuits, Integrated Power Electronics.

ACADEMIC PROJECTS
* LED Driver and Photo receiver [Analog Circuits, SPICE]
* Designed, laid out and simulated a chip for fabrication that drives an LED and detects the received light signal.
* Voltage Controlled Oscillator was designed to drive a particular led specification.
* Designed a High Gain Amplifier with low power consumption to detect the received light signal.
* Implemented a Detection Circuit to trigger an alarm above a reference voltage.

* Electronic Security System [Verilog, FPGA, Xilinx]
* Designed and Burnt a FPGA combination lock circuit for security systems.
* Implemented the logic in Verilog using Xilinx ISE 10.1 and tested simulations on ModelSim.

* ASIC Multiplier and Accumulate Unit [VLSI,Cadence]
* Designed, laid out and simulated an ASIC CMOS based Multiply–Accumulate circuit using Cadence SpectreS in 0.6 micro meter technology.
* Implemented the Modified Booth Algorithm and obtained substantial gain in calculation time.

* RF Microwave Research [Spectrum Analyzer, HFSS]
* Independently involved in research by conducting experiments to study the mode conversion in RF microwave waveguides. Cut-Off frequencies in spectrum analyzer were compared with HFSS.
* Comprehensive research and study was performed on various components and equipments like antenna, dielectric material and waveguides.

PROFESSIONAL EXPERIENCE
Engineer I, Larsen and Toubro InfoTech LTD, India June 2006 - July2007
* Designed, Developed and provided technical support for Migration management system.
* Worked, interacted with Freescale Semiconductor and other clients for system requirements and specifications. Fixed multiple production problems in record time.
* Received an award for outstanding performance and growth.

EXTRA CURRICULAR ACTIVITIES
* Vice President, Electrical Engineering Graduate Student Association at SUNY, Buffalo.
* International Student and Scholarly Services Orientation Volunteer, August 2008.
* Volunteer Assistant to fellow student with a disability, fall 2008.

View contact information...

«« previous resume

next resume »»

Search Results (Resumes 1451 to 1500 of 2526)

Go to Search Parameters...

Brief Description

Basic Soft Skills (Communication Skills, Presentation Skills, Team Working, Technical & Business Writing)

3rd Year Enviromental Technologist

Oil & Gas Exploration Project Manager - Spring Creek, Nevada resident - Forest Service, BLM , Tribal, State & Federal liason experience

Sales, Engineering Project Manager

Mining and geological engineer from the university of Liege with a specialization in geophysical methods and geotechnics.

Project Manager, Field Engineer, Commissioning Electrical Switchgear

ISO/ASNT certified Vibration analyst ,More than three years of engineering experience ,Analytical skills and self learning ability,committed to any work unconditionally,Able to work under pressure,Able to liaison between technical groups ,Proven ability to improve efficiency

I have 3 years experience in the Design industry. I self taught myself on AutoCad and Microstation.

Ellipse Business Analysis Skills in the Area of Asset Management, Work Management, Purchasing, Warehouse, Catalogue, and others.

Administrative Coordination, Legal Research, Legal Administration & Analysis, Evaluation & Monitoring, Case Management, Project Management, Outreach, and Computing.

Have been a rigger/ironworker for 10 years+. Have experience in welding and have done this on/off for 8 years.

Experience in Instruments of PERKIN ELMER and applied bio-system, installation, commissioning, maintenance, and calibration of various instruments;

Electrical Engineer with wireless, optical and integration expertise

Applying for the post of safety officer in your esteemed concern

Purchaing, Procurment, Supply Chain Management, Materails, Inventory

Mechanical/Manufacturing Engineering, Project/Program Management, Supply Chain Management

PhD (Geology), Post MSc Diploma (Hydrogeology), MSc (Applied Geology). Working as GIS Professional and previously worked as Geologist, Lecturer in Environmental Science and GIS Professional.

Sound oil & gas production operations and excellent management skills.

Technical/General English Instructor. Certified. BA and MA. Employed in field since 1988. Overseas experience in Middle East and Far East including oil and gas industry.

Pip in indistrial safety, working in ministry of elec & water ,kuwait.

Computer Technician

Principal Environmental & Safety Consultant, oil, gas, mining & major projects; EIA, EMS, Environmental risk etc, climate change, HAZOP, HAZID, Safety managment etc experience. Relocating to Vancouver. Has right to live and work in Canada

Automobile related

Electrical Engineering, Energy Systems, Power electronics

I am Diploma in Mechanical Engineering. I have adequate knowledge in Auto-Cad in mechanical engineering field. I also have confident experience in X-Steel & SDS2 in steel structure back ground.

Graduate Electrical with Power Electronics

B.Com (Commerce, MS-Word, MS-Excel, Tally, Emails, Internet & Other Software

At present doing a 2 year contract at a bulk fuel installation, in Basrah, Iraq, as an Operator. I have 25 years experience as a fire fighter and paramedic and the last 2 years have been doing aviation and road fuels at an Airport and bulk fuel installation

Prevent / correct unsafe acts & condition.

Project Manager - Sales - Technical

I am 26 years old engineer of hydraulic and searching for traineeship in companies in Germany, Austria, Italy to get more and better experiences in my field of work and to grow in knowledge.

Over twenty years of experience

Mining Engineer with 20+ years experience, Supervisor of Drilling Crews, great work ethic, will meet deadlines and bottom line, effective team builder

Procurement & Supply Chain Management

Quality Management, ISO 9001, ISO 14001, OHSAS 18001, Lead Auditor of IRCA, TUV-CERT

Seeking Chemist, Laboratory, or Quality Control Position

Worked in an oil and gas industry and undergone an intensive training .

Seeking International, full-time position in Central, South America with a mining company for the development and management of capital projects. Peruvian Residency Available, Spanish, Project Management and Construction Experience with Heap Leach and Tailings Facilities

MS-GIS, International MBA, Fluent english and spanish, basic Arabic

Graduate Botanist, four year science degree, environmental consultancy, surveying, vegetation analysis, climate studies, administration,

Manager / Engineer ( HW/SW/QA/Training )

Sociable, well educated, friendly

Extensive skills in composites, operations management, plant management, as well as manufacturing of high speed offshore vessels.

Experience with Electrical and Instrumentation & Control Systems design which encompasses project estimating, equipment purchasing, design, build, programming, installation, start-up (commissioning) and field service/troubleshooting for the following: AC motor controls, MCC’s, VFD’s, MOV’s, AOV’s,

Marine + International Projects Oil & Gas

Technical Project Manager

PE in Mining, Environmental & Civil Engineering with 26+ years experience in surface coal mining management, engineering & environmental. I've held positions up to and including Vice-President of Operations. Well experienced in open pit dragline & truck/shovel operations. Well organized.

Piping/Mechanical Draughtsman (sewerage plant/Oil & gas)

B.Sc. in Environmental Engineering; M.Sc. in Engineering Management; ISO9001, ISO14001, OHSAS18001; EIA reports; EMMPs; translation (English / Turkish); MIDSS; management

Quailty Coordinator, Welding Specialist, Safety Training Coordinator, Operations Coordinator Prefer Former CIS Russia, Kazakhstan

First 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 [ 30 ] 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 Next Last

Seach Parameters


Change search parameters...
INDUSTRIES: Environmental;
Change search parameters...
Keywords: (e.g. mining engineer)		Find results with:


Save this search parameters...
Post job with this search parameters...

Frequently Asked Questions

What's the most effective way to perform a search?
Go to Advanced Search
1. Select 'Industries', 'Categories', 'Education', and 'Experience' fields. Click 'Search' and look through results.
2. Enter one or two of the most important keywords. Click 'Search' and look through results.
3. To search within results add more keywords.

How can I find resumes that contain specific exact phrase?
To search for an exact phrase, just put quotation marks around two or more words, for example "mining engineer". Use this feature to narrow your results or to find words that can be typed differently, for example AutoCAD "Auto CAD".

More Frequenly Asked Questions...

Employer's Center

» Employers Home

» Feedback

» Help

» Post Jobs

» Edit/Delete Jobs

» Search Resumes

» Resumes By Email

» My Account

» Log In

» Log Out